Power Steering Fluid — Filling and Bleeding (Nissan Bluebird T12)

1. When topping up, use only good quality fluid of the type used.

2. Check the fluid level in the reservoir.

3. The system needs to be bled if the fluid level has dropped so much that air has entered the system (air bubbles in the liquid or clicking or humming sounds from the pump). First turn off the engine, then remove the filler cap of the tank, add liquid to the "Max" level.

4. Apply the handbrake. Raise the front of the car.

5. Quickly turn the steering wheel from lock to lock several times, then recheck the fluid level and top up if necessary.

6. Repeat the adjustment and top up again until the fluid level stops dropping, then start the engine and set the idle speed. Turn the steering wheel ten times from lock to lock as described above, stop the engine, allow the fluid level to settle and top up if necessary.

7. When the level has stabilized, lower the car and drive a few kilometers to warm up the fluid and system components and remove any remaining air. Stop the engine, allow the fluid to cool completely, then top up if necessary.