Car Repair — Ultrasonic Sensor (Nissan X-Trail T31)

1. Ultrasonic sensor

Removal and installation

Removal

1. Remove the ultrasonic sensor trim.

2. Remove the mounting screws (A) from the ultrasonic sensor and disengage the latches.

[The text is published on the website NISSANBOOK.ru]

3. Remove the ultrasonic sensor (2) from the trim (1).

3. Remove the ultrasonic sensor (2) from the trim (1).

Installation

Installation is performed in the reverse order of removal.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article has been reviewed: Andrey Lazarev

Send this information to your friends:

◀ Previous

X-Trail 2: Doors, locks and windows

Next ▶

Car Repair — NATS Antenna Booster
Car Repair — Smart Key Unit
Smart Key Block
Smart key power supply
Rear Door Request Switch

Car Repair — Hood Switch
Security alarm control system (on models without smart key) — NATS antenna booster
Security alarm control system (on models without smart key) — ultrasonic sensor
Security alarm control system (on models without smart key) — bonnet switch
Windshield

Similar information for other Nissan models

➜ Checking the oxygen sensor Nissan Almera 1 (1995-2000)
➜ Preparatory actions and a list of repair procedures without… Nissan Maxima 4 (1994-1999)
➜ Introduction to the repair manual Nissan Murano 1 (2002-2007, petrol)
➜ Oxygen sensor Nissan Terrano 1 (1986-1995, petrol)
➜ Servicing the Start Permission Switch Sensor Nissan Patrol 4 (1987-1997, petrol)
➜ Ignition distributor — removal, installation and repair Nissan Primera 1 (1990-1996, petrol)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet