Oxygen sensor (Nissan Terrano 1)
1. The sensor is screwed into the exhaust manifold. Disconnect the wires and unscrew the sensor. Install the new sensor in the reverse order.
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This article has been reviewed: Andrey Lazarev
Checking and setting the ignition timing
Distributor Cap and Rotor Runner — Checking and Replacing
High Voltage Wires — Checking and Replacing
Replacing spark plugs
Checking and replacing the crankcase ventilation valve
Distributor Cap and Rotor Runner — Checking and Replacing
High Voltage Wires — Checking and Replacing
Replacing spark plugs
Checking and replacing the crankcase ventilation valve
Similar information for other Nissan models
➜ Checking the oxygen sensor Nissan Almera 1 (1995-2000)
➜ Checking the condition and replacing the oxygen sensor… Nissan Maxima 4 (1994-1999)
➜ Oxygen sensor (lamda probe) Nissan Murano 1 (2002-2007, petrol)
➜ Oxygen sensor Nissan Serena 2 (1999-2005)
➜ Servicing the Start Permission Switch Sensor Nissan Patrol 4 (1987-1997, petrol)
➜ Fuel Level Gauge Sensor Module — Device Nissan Qashqai 1 (2006-2013)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Engines 4-cylinder
- Engines 6-cylinder
- Engine overhaul
- Cooling and ventilation
- Fuel and exhaust systems
- Engine electrical equipment
- Decreased toxicity
- Transmission
- Mechanical gearbox
- Automatic gearbox
- Clutch and drive shafts
- All-wheel drive system
- Chassis
- Brake system
- Car suspension
- Steering
- Body and electrical equipment
- Body elements
- Doors, locks and windows
- Equipment and devices
Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.