Vehicle all-wheel drive system Nissan Terrano 1 (WD21)

All-wheel drive system specifications
Front wheel hubs Preload of bearings 2.15-6.4 Nm. Axial play of the axle shaft 0.1-0.3 mm Thickness of axle shaft adjusting washers 1.1-2.1 mm in 0.2 mm increments...

General information about the all-wheel drive system
The rear wheel drive of 4x4 and 4x2 vehicles is the same. The chassis of 4x4 vehicles differs only in the front wheel drive (photo). The transfer case is mounted in the...

Self-locking hub device — removal and installation
1. Remove the wheel 2. Unscrew 6 bolts 3. Carefully remove the hub body, ring, spring and driver A (locking ring, photo). 2.3 Details of the self-locking device 1. Hub...

Half shafts — removal and installation
1. Raise the vehicle and place it on stands. 2. Remove the wheel. 3. Remove the self-locking device. 4. Remove the retaining ring from the axle shaft journal. 5. Remove...

Half shaft — disassembly and assembly
1. Remove the axle shaft. 2. Clamp the axle shaft in a vice through a soft pad. 3. Carefully knock off the axle shaft flange from the differential side and release the...

Hub and steering knuckle — removal and installation
1. Raise the front of the vehicle and place it on stands. 2. Remove the wheel. 3. Remove the caliper ( Ch. 10 ) and take it aside. 4. Remove the axle shaft. 5. Loosen...

Hub seals — removal and installation, bearing adjustment
1. Remove the hub and knuckle. 2. Loosen the lock plate screw. 3. Unscrew the lock nut and secure the hub (photo). 6.3 Fixing the hub when unscrewing the nut 4. Remove...

Front propeller shaft — removal and installation
1. Mark the position of the cardan shaft on the flanges of the gearbox and transfer case. 2. Loosen the bolts and remove the shaft. 3. If necessary, remove the fork from...

Front axle seals — replacement
Main gear pinion seal 1. Drain the oil from the gearbox housing. 2. Raise the front of the vehicle and place it on stands. 3. Disconnect the cardan shaft from the front...

Front gearbox — removal and installation
1. Raise the front of the vehicle and place it on stands. 2. Drain the oil from the gearbox. 3. Disconnect the front propeller shaft from the gearbox. 4. Loosen the...

Transfer case seals — replacement
1. Raise the front of the car and place it on stands. Remove the shields and drain the oil from the gearbox. 2. Mark the position of the propeller shaft relative to the...

Transfer case — removal and installation
1. Disconnect the battery from ground. 2. Raise the front of the vehicle and place it on stands. 3. Remove the gearbox shields and drain the oil from the gearbox. 4....

Transfer case — disassembly
Disassembly and repair of the transfer case is carried out in a car service center (or a specialized workshop) due to the complex technology of the work and the need to...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Send this information to your friends:

Link in different formats to this section

TEXTHTMLBB Code