Ignition system — general information The ignition system of the cars in question consists of a distributor with a crankshaft rotation sensor, a coil, spark plugs, wires and an electronic switch. The...
Ignition system — check 1. If the starter cranks the crankshaft and the engine does not start, then inspect the condition of the wires, spark plugs, distributor cap and runner. 2. If all these...
Ignition distributor — removal 1. Disconnect from the distributor of a wire from the coil of ignition. 2. Remove the distributor cap. 3. Mark the position of the slider relative to the distributor...
Ignition distributor — installation If, after removing the distributor, the position of the crankshaft was not violated 1. Turn the slider to the position indicated before removing the distributor. 2....
Crankshaft rotation sensor — check 1. Turn on the self-diagnosis mode ( Ch. 6 ) and check for faults in the fuel system. 2. A malfunction of the crankshaft rotation sensor circuit is indicated by 1 flash...
Ignition coil — removal and installation 1. Disconnect the high voltage wire from the coil. 2. Remove the cap from the coil and disconnect the low voltage wires by unscrewing the nuts. 3. Turn away bolts of...
Engine starting system — general information The system consists of a starter and a traction relay. On car parts (made for Canada) starters are installed with a gearbox, which is designed to increase torque at low...
Engine starting system — check 1. If the starter does not turn on at all when the key is turned, then make sure that the selector lever is in position P or N (on vehicles with automatic transmission)....
Starter — removal and installation 1. Disconnect the battery from the ground. If the vehicle has a V6 engine, jack the vehicle up and place it on stands. 2. Label and disconnect wires (photo). 9.2 Starter...
Traction relay — removal and installation 1. Remove the starter. 2. Turn away a terminal nut on the traction relay and disconnect a wire. 3. Turn away screws and remove the relay. 4. Installation is carried out...
Starter — brush replacement Starter without gear 1. Remove a starter and the traction relay. 2. Remove the rear seal (photo). 11.2a Starter parts (without gear) 1. Traction relay parts; 2. Gaskets;...
Charge system — general information The system consists of a generator, a voltage regulator and a battery. The regulator is integral, built into the generator housing. The output voltage is not subject to...
Generator — care and precautions 1. Periodically wipe the generator, remove dirt and traces of grease. 2. Check belt tension ( Ch. 1 ). 3. The generator bearings are sealed and do not need to be...
Charge system — check 1. Before testing a failed charge system, fully charge the battery. 2. Check the condition of all wires and connections. 3. Be convinced of ignition of a control lamp...
Generator — removal and installation 1. Disconnect the battery from the ground. Raise the front of the car. 2. Label and disconnect the wires from the generators. Remove the belt. 3. Turn away an adjusting...
Voltage regulator and brushes — replacement 1. Remove the generator. 2. Loosen the 4 pinch bolts on the rear cover (photo). 16.2 Generator parts (without rear dust cover) 1. Coupling bolt; 2. Back cover; 3. Brush...