Starter without gear
1. Remove a starter and the traction relay.
2. Remove the rear seal (photo).
11.2a Starter parts (without gear)
1. Traction relay parts; 2. Gaskets; 3. Spring; 4. Lever; 5. Seal; 6. Sleeve; 7. Front cover; 8. Retaining ring; 9. Restrictive sleeve; 10. Overrunning clutch; 11. Partition; 12. Anchor; 13. Excitation winding
11.2b Starter parts (without gear) rear-wheel drive vehicles with 4-cylinder engine
1. Traction relay; 2. Anchor; 3. Seal; 4. Lock washer; 5. Thrust washer; 6. Back cover; 7. Rear hub; 8. Brush holder; 9. Brush (-);10. Brush (+) 11. Yarmo
11.2c Starter parts (without gear) all-wheel drive vehicles with 4-cylinder engine
1. Shims (thickness 0.5 or 0.8 mm); 2. Traction relay; 3. Back cover; 4. Yoke; 5. Excitation winding; 6. Brush (+); 7. Anchor; 8. Brush holder; 9. Lever
3. Get a lock ring and a persistent washer.
4. On the back cover, unscrew the two brush holder screws.
5. Turn out coupling bolts and remove a back cover.
6. Take out the brush holder (photo), take away springs and get brushes. If the height of the brushes is less than 12 mm, then desolder them and solder new ones.
11.6 Starter brush holder
7. Reassemble the starter in reverse order.
Starter with gearbox
8. Remove a starter and the traction relay.
9. Remove the tie bolts (photo).
11.9a Starter parts (with gearbox) cars with 4-cylinder engine
1. Traction relay; 2. Shim (sealant); 3. Spring; 4. Lever; 5. Front cover; 6. Gear housing; 7. Gasket; 8. Drive gear; 9, 18. Ring; 10. Anchor
11.9b Starter details (with gearboxes) vehicles with V6 engine
1. Traction relay; 2. Orbital gear; 3. Back cover; 4. Seal; 5. Bolt; 6. Anchor; 7. Yoke; 8. Partition; 9. Washers; 10. Brush holder; 11. Planetary gears; 12. Drive gear
10. Remove the back cover without damaging the rings.
11. Separate the yoke assembly with anchor and brush holder from the cover.
12. Take away the springs and remove the brushes from the brush holder (photo), unsolder and solder new (if the height of the brushes is less than normal).
11.12 Pull back the springs and remove the brushes
1. Brush holder; 2. Hook; 3. Brush
13. Reassemble the starter in reverse order.