Table of contents: Removal ↓ Installation ↓
Attention: All work is carried out after disconnecting the cable from the negative terminal of the battery.
Removal
1. Remove the air duct.
2. Loosen the mounting bolt at the top of the starter.
3. Remove the front exhaust pipe.
4. Remove the front intake manifold support.
5. Disconnect terminals S and B.
6. Remove the oil pressure warning light switch wiring connector.
7. Unscrew the mounting bolt at the bottom of the starter (2WD models) or a fastening nut (4WD models) and remove the starter from the bottom of the car.
Installation
Install in the reverse order of removal.