Vehicle passive safety system Nissan Serena 2 (C24)
Location of components of airbag modules and seat belt pretensioners
Location of components of airbag modules and seat belt pretensioners
Location of components of airbag modules and seat belt pretensioners
Driver airbag module
Four spoke steering wheel Attention: Before proceeding with removal, turn the ignition key to the OFF position, disconnect both cables from the battery and wait at least...
Four spoke steering wheel Attention: Before proceeding with removal, turn the ignition key to the OFF position, disconnect both cables from the battery and wait at least...
Front Seat Side Airbag Modules
Attention: Before proceeding with removal, turn the ignition key to the OFF position, disconnect both cables from the battery and wait at least 3 minutes. Perform work...
Attention: Before proceeding with removal, turn the ignition key to the OFF position, disconnect both cables from the battery and wait at least 3 minutes. Perform work...
Side impact sensor
Preparatory work Remove the front and rear door sill trims. Remove the lower center pillar trim. Remove the front seat belt (seat belt pretensioner). Attention: Before...
Preparatory work Remove the front and rear door sill trims. Remove the lower center pillar trim. Remove the front seat belt (seat belt pretensioner). Attention: Before...
Seat belt pretensioners
Removal and installation For removal and installation work, see chapter Interior equipment .
Removal and installation For removal and installation work, see chapter Interior equipment .
Airbag Sensor Unit — Device
Preparatory work Disconnect all airbag module and seat belt pretensioner connectors. Remove the pillar trim. Remove the front floor level air duct. Note: To unscrew the...
Preparatory work Disconnect all airbag module and seat belt pretensioner connectors. Remove the pillar trim. Remove the front floor level air duct. Note: To unscrew the...
Airbag Sensor Block — Check
Attention: Diagnose the system using the self-diagnosis function and the CONSULT tester. Do not use electrical equipment such as testers to check SRS circuits (to avoid...
Attention: Diagnose the system using the self-diagnosis function and the CONSULT tester. Do not use electrical equipment such as testers to check SRS circuits (to avoid...
Security system diagnostics
Airbag system Self-diagnosis Diagnostics are performed in one of two modes: user and diagnostic. Switching between modes is performed using the ignition key and the...
Airbag system Self-diagnosis Diagnostics are performed in one of two modes: user and diagnostic. Switching between modes is performed using the ignition key and the...
Checking the spiral wire
Disconnect the connector on the air bag module side and the coil wire connector on the air bag sensor assembly side. Check if there is conductivity between the...
Disconnect the connector on the air bag module side and the coil wire connector on the air bag sensor assembly side. Check if there is conductivity between the...
This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Similar information for other Nissan models
➜ Body: Safety system Nissan Qashqai 1 (2006-2013)
➜ Body: Safety system Nissan Almera 1 (1995-2000)
Link in different formats to this section
TEXTHTMLBB Code
- General information
- Control devices
- User manual
- Power unit
- Petrol engine SR20DE
- Diesel engine YD25DDTi
- Cooling and lubrication system
- Engine management SR20DE
- Engine management YD25DDTi
- Power and exhaust system
- Transmission
- Automatic gearbox
- Drive and cardan shafts
- Transfer case
- Chassis
- Front suspension
- Rear suspension
- Brake system
- Steering
- Body
- Safety system
- Interior (internal elements)
- Exterior (external elements)
- Doors, locks and windows
- Heating and air conditioning
- Electrical equipment
- Equipment and devices
- Lighting system
- Windshield wipers and washers
- Electrical circuits
Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.