Power steering fluid Liquid level check Check the fluid level with the engine not running. Make sure the fluid level is between the MAX and MIN·marks on the reservoir. The level should not...
Steering wheel Backlash check 1. Turn the steering wheel to the straight ahead position. Start the engine and turn the steering wheel slightly left and right until the front wheels...
Steering Gear Case — Offset Check When the steering wheel is turned, the steering gear housing is displaced due to the elastic deformation of the rack mounting insulator. Check the amount of offset. 1....
Oil pump unloading pressure — check Before performing the procedure below, check the belt tension. 1. Raise the car. Connect oil pressure gauge (special tool) and adapter (special tool) between outlet...
Steering wheel — removal and installation Removing 1. Remove the airbag module. See ch. Additional passive safety system . 2. Disconnect all connectors. 3. Turn off a fixing nut of a steering wheel and apply...
Lower hinge and steering column hole cover Removing 1. Raise the vehicle with the front wheels straight ahead. 2. Paint marks on the lower pivot and steering gear. Loosen the pinch bolt under the lower hinge. 3....
Steering column assembly — removal and installation Removing Attention: During removal and installation, do not subject the steering column to impacts in the axial direction. 1. Remove the steering wheel and steering...
Steering column assembly — disassembly and assembly Disassembly Attention: Disassembly and assembly should be carried out when the steering column lock is released. 1. Remove the combination switch from the pipe. 2....
Steering gear — removal and installation Removing 1. Remove cotter pins and loosen fixing nuts. Press the tie rods out of the steering knuckles using a suitable puller. Attention: Do not damage the anthers on...
Steering gear — disassembly During disassembly and assembly of the steering mechanism, fix its flanges in a vise by laying copper plates. Before dismantling, clean the steering gear with clean...
Steering gear — check Cases Check the condition of the cover. Replace if worn or deformed. Rail Check the working surface of the rail. Replace if worn or damaged. Steering gear assembly Check...
Steering gear — assembly 1. Install o-rings. Attention: Do not reuse O-rings, replace them with new ones. 2. Using a hair dryer, heat the Teflon ring to a temperature of 40°and install it on the...
Tubes, hoses and power steering pump Attention: Disassemble the power steering pump and check for scratches on the housing, rotor, vanes and valve. Replace the pump assembly if necessary. Locate oil leaks....
Power steering pump — removal and installation Removing Petrol engine models 1. Loosen the adjusting screw and pump mounting bolts. Then remove the belt. 2. Turn off connecting bolts and disconnect hoses from the...
Power steering pump — disassembly and assembly 1. Clamp the pump in a vise. Attention: When clamping in a vise, lay aluminum plates, etc., so as not to damage the pump. 2. Unscrew the 2 fixing bolts of the bracket...
Spiral wire Preparatory work Remove the driver's airbag module. Remove the steering wheel. Remove the steering column cover. Removing Disconnect the steering wheel angle sensor...
Front Passenger Airbag Module Attention: Before removing, turn the ignition key to the OFF position, disconnect both cables from the battery and wait at least 3 minutes. Work from the side of the...