Attention:
Before removing, turn the ignition key to the OFF position, disconnect both cables from the battery and wait at least 3 minutes.
Work from the side of the module.
Removing
1. Remove the glove box, disconnect the wiring connector.
2. Remove the lower section of the dashboard from the front passenger side.
3. Turn out special bolts and nuts and take out the airbag module from the dashboard.
Installation
Installation is carried out in the reverse order of removal, taking into account the following:
Attention:
Check that there is no gap between the contact surface of the airbag module and the instrument panel.
Do not pinch the electrical wiring.
Do not reuse special bolts, replace them with new ones.
After installation, check if the system is working properly by observing the airbag warning light.
If the airbag warning lamp indicates any abnormality, use the self-diagnosis function or the CONSULTI tester to erase the memory.
If the airbag warning light still indicates a malfunction, run system diagnostics. Repair defective components.