Exterior (external elements) of the car Nissan Serena 2 (C24)
Front bumper Remove the front grille and fender guards. Disconnect the fog light connectors (if any). Disconnect the sonar connectors (if any). Removing the bumper cover Insert a...
Rear bumper Remove the side luggage compartment boxes. Detach the rear side protectors (if any).
Front grille To remove the mount, insert a screwdriver through the front grille and rotate the mount 45°.
Protective pads Protective wing pads Protective sills Rear side protectors
Moldings — removal and installation Exterior door moldings Preparatory work Remove the door trim. Remove the outside rearview mirror. Removing Bend and pull up the rear edge of the molding and remove from...
Front pillar pads Removing unscrew the screw (1), insert a plastic or wooden spatula (2), release the clamps (3), then release the tabs. Note: Insert the spatula in close proximity to the...
External rear-view mirrors — general information Precautionary measures Do not operate the power folding door mirrors manually. If you fold / unfold the mirrors manually, press the switch and move the mirror completely...
External rear-view mirrors — disassembly and assembly Disassembly Turn the surface of the mirror glass up. Stick the tape on the mirror housing. Insert a screwdriver into the gap between the mirror (holder) and holder...
Windshield — general information Preparatory work Remove the A-pillar trim and the headlining front trim. Remove the front strut seal. Remove the front strut pads. Remove the hood top cover. Disconnect...
Windshield — removal and installation Removing 1. Apply protective tape around the perimeter of the windshield and along the ribs of the side moldings to prevent damage to painted surfaces. 2. Using a knife,...
Bonnet Cover — Fit Adjustment Gap adjustment left and right Adjustment area: hood hinges. Close the bonnet slightly and adjust its height so that it is flush with the left and right fenders. Stand at...
Hood cover assembly Removal and installation 1. Disconnect washer hoses at their connection. 2. Turn off fixing nuts of hinges of a cover of a cowl. 3. Remove the hood cover.
Bonnet release cable Removing Disconnect the cable from the hood lock, release the cable from the clamps on the radiator core support and the side clamps. Remove the sleeve from the bulkhead...