Exterior (external elements) of the car Nissan Qashqai 1 (J10)
Precautions when working on car body parts When removing or disassembling any part, be careful not to damage or deform them. Parts that may interfere with work must be covered with a cloth. When removing parts...
Precautions when working on the instrument panel Disconnect both wires from the battery. Disconnect airbag system line beforehand. Do not use force to open the cover of the airbag module, as this may cause the airbag...
Precautions when working on body glazing Carefully read the date of manufacture of the adhesive indicated on the package. The shelf life of glass adhesive is limited to six months from the date of manufacture....
Front bumper — device Note. : clip. : fixer. : metal clip. : replace the part with a new one after each removal. Front bumper, versions before restyling in 2010: 1. Facing the front bumper...
Front bumper — removal and installation Attention. The bumper cover is made of epoxy resins. Do not force it or allow it to come into contact with oils. Removing 1. Fully open the hood. 2. Remove the front...
Rear bumper — device 1. Facing the rear bumper assembly. 2. Energy storage. 3. Central holder of the rear bumper. 4. Side holder of the rear bumper. 5. Rack rear bumper. 6. Side bracket A...
Rear bumper — removal and installation Attention. The bumper cover is made of epoxy resins. Do not apply force to it and avoid contact with oils. Removing 1. Fully open the tailgate. 2. Loosen the screws (A)...
Front grill — device Models before restyling in 2010: 1. Front emblem. 2. External grille. 3. Internal grille. 4. Top fixing clips. 5. Fixing clips. Models after restyling in 2010: 1. Front...
Front grill — removal and installation Attention. Apply protective tape to the body surfaces around the front grille (particularly on the front bumper). Removing 1. Fully open the hood. 2. Remove the upper...
Upper part of the hood — device 1. Upper part of the hood. 2. Grille cover the top of the hood. 3. Hood top cover. 4. Seal the top of the hood. 5. Front fender cover. 6. Foam insulator of the upper...
Upper part of the hood — removal and installation Removing 1. Fully open the hood. 2. Remove the left and right front wiper arms from the vehicle. 3. Remove the left and right identification covers from the vehicle. 4....
Fenders — device Front fender: 1. Front fender liner. 2. Mudguard of the supporting edge of the hood. 3. Front fender. 4. Front fender cover. 5. Front fender bracket. 6. Front fender...
Fenders — removal and installation Removing front fender liner 1. Remove the front mudguard (if equipped). 2. Remove the screws and bolts securing the front fender liner. 3. Remove retaining clips (A)...
Moldings and decorative elements of the body Mudguards: 1. Front mudguard (if equipped). 2. Rear mudguard (if equipped). Note. : clip. wheel arch moldings: 1. Front wheel arch molding. 2. Molding rear wheel arch....
Body center marks Center marks are located on each body part to determine the center of the vehicle. When restoring parts damaged as a result of a collision that can break the geometry of...
Body colors Note. 2S: Auto Enamel + Clear Lacquer M: Metallic R: Two-layer mother-of-pearl 3P: Three-layer mother-of-pearl FPM: Iron oxide mother of pearl RPM: Color changeable...
Plastic body parts Attention. When restoring painted body parts adjacent to plastic parts, the characteristics of the plastics must be taken into account (resistance to heat and solvents),...