Car steering Nissan Qashqai 1 (J10)
Precautions when working with passive safety elements
Supplemental Restraint System (SRS) components such as airbags and seat belt pretensioners work in conjunction with seat belts to reduce the risk or severity of injury...
Supplemental Restraint System (SRS) components such as airbags and seat belt pretensioners work in conjunction with seat belts to reduce the risk or severity of injury...
General Precautions When Working with the Steering System
When disassembling the steering gear, the following precautions must be observed: If the steering gear assembly is removed from the vehicle, perform final tightening of...
When disassembling the steering gear, the following precautions must be observed: If the steering gear assembly is removed from the vehicle, perform final tightening of...
Checking the installation condition of the steering system components
1. Check the installation condition of the steering gear assembly, front suspension assembly, axle and steering column assembly. 2. Check the ability to move the...
1. Check the installation condition of the steering gear assembly, front suspension assembly, axle and steering column assembly. 2. Check the ability to move the...
Checking the steering wheel play
1. Turn the steering wheel so that the front wheels of the car are in a straight-ahead position. 2. Start the engine and smoothly turn the steering wheel left and right...
1. Turn the steering wheel so that the front wheels of the car are in a straight-ahead position. 2. Start the engine and smoothly turn the steering wheel left and right...
Checking the neutral position of the steering wheel
Check the neutral position of the steering wheel after adjusting the steering wheel alignment angles. 1. Make sure the steering gear assembly, steering column and...
Check the neutral position of the steering wheel after adjusting the steering wheel alignment angles. 1. Make sure the steering gear assembly, steering column and...
Steering wheel — device
1. Steering wheel. Note. : replace the part with a new one after each removal.
1. Steering wheel. Note. : replace the part with a new one after each removal.
Steering wheel — removal and installation
Removal Note: When disconnecting the contact disk, secure its housing with tape to prevent it from turning. This will eliminate the need to adjust the neutral position...
Removal Note: When disconnecting the contact disk, secure its housing with tape to prevent it from turning. This will eliminate the need to adjust the neutral position...
Steering column — removal and installation
Attention. Avoid hitting the steering column when removing it. Apply alignment marks to the intermediate shaft and steering column assembly before removing the...
Attention. Avoid hitting the steering column when removing it. Apply alignment marks to the intermediate shaft and steering column assembly before removing the...
Steering gear — device
1. Lower steering column seal. 2. Steering gear assembly. 3. Front suspension subframe. Note: The arrow in the illustration indicates the front of the vehicle.
1. Lower steering column seal. 2. Steering gear assembly. 3. Front suspension subframe. Note: The arrow in the illustration indicates the front of the vehicle.
Removal and installation the steering gear
Removal 1. Set the vehicle wheels to the straight-ahead position. 2. Loosen the intermediate shaft bolt (from the bottom side), and then remove the intermediate shaft...
Removal 1. Set the vehicle wheels to the straight-ahead position. 2. Loosen the intermediate shaft bolt (from the bottom side), and then remove the intermediate shaft...
Disassembly and assembly of the steering gear
1. Tie rod end. 2. Tie rod end lock nut. 3. Small boot clamp. 4. Dust cover. 5. Large boot clamp. 6. Steering gear housing assembly. Note. : replace the part with a new...
1. Tie rod end. 2. Tie rod end lock nut. 3. Small boot clamp. 4. Dust cover. 5. Large boot clamp. 6. Steering gear housing assembly. Note. : replace the part with a new...
Service data and specification
General specification Steering gear model: R27N Steering wheel Backlash values Steering wheel effort Effort required to turn the steering wheel, N (kgf): 7 (0.71)...
General specification Steering gear model: R27N Steering wheel Backlash values Steering wheel effort Effort required to turn the steering wheel, N (kgf): 7 (0.71)...
Steering rods: service data
Rotational resistance and breakaway torque Axial play of the ball joint pin Length of inner part of steering rod Neutral position of the steering rack (dimension "L"),...
Rotational resistance and breakaway torque Axial play of the ball joint pin Length of inner part of steering rod Neutral position of the steering rack (dimension "L"),...
This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Similar information for other Nissan models
➜ Chassis: Steering Nissan Maxima 4 (1994-1999)
➜ Chassis: Steering Nissan X-Trail 2 (2007-2013, petrol)
➜ Chassis: Steering Nissan Terrano 1 (1986-1995, petrol)
➜ Chassis: Steering Nissan Sunny 7 (1990-1998)
➜ Chassis: Steering system Nissan Murano 1 (2002-2007, petrol)
➜ Chassis: Steering Nissan Note 1 (2004-2013)
Link in different formats to this section
TEXTHTMLBB Code
- General information
- Faults en route
- Daily checks
- User manual
- Maintenance
- Power unit
- Petrol engines 1.6L (HR16)
- Petrol engines 2.0L (MR20)
- Diesel engines 1.5L (K9K)
- Diesel engines 2.0L (M9R)
- Cooling system
- Engine lubrication system
- Engine power system
- Engine management system
- Intake and exhaust system
- Engine electrical equipment
- Transmission
- Clutch
- Car gearbox
- Transfer case and shafts
- Chassis
- Car suspension
- Brake system
- Steering
- Body
- Exterior (external elements)
- Interior (internal elements)
- Safety system
- Heating and air conditioning
- Electrical equipment
- Wiring harnesses
Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.