General steering repair instructions Thoroughly clean the outer surfaces of parts before disassembly. Disassembly must be carried out in a clean room. It is necessary to completely exclude the ingress of...
Special and standard tools and fixtures Special tools and fixtures KV4810070G Adapter for measuring the torque of the drive gear KV48102500 Pressure adapters ST27180001 Steering wheel puller HT72520000 Ball...
Checking the steering on a car Total steering play Set the wheels to a straight ahead position and measure the steering wheel free play (on the rim). Steering wheel free play - no more than 35 mm If...
Removal and installation of a steering wheel Models with airbag Before removing the steering wheel, remove the airbag module and coiled cable (see chapter « Safety system »). When installing the steering wheel, the...
Removal and installation of the steering column When installing the steering column, first tighten all the bottom bracket bolts with your fingers; then tighten them to the required torque. Do not apply excessive force...
Disassembly and assembly of the steering column When disassembling and assembling, unlock the steering shaft with the key. Install the locknut on the steering shaft and tighten it to the specified torque. Tightening...
Checking the steering wheel and steering column If the steering wheel does not turn smoothly, check the steering column as described below and replace the damaged parts. Check steering column bearings. They should...
Steering gear without power — device 1. Cover hole in the bulkhead 2. Steering shaft lower joint 3. Steering gear 4. Steering bracket 5. Steering gear support 6. Split pin Steering parts without power...
Steering gear without power — removal and installation WARNING: The coiled airbag cable allows limited rotation. Set the wheels straight ahead and do not turn the steering wheel after removing the steering gear. You press...
Power Steering (Model PR24AC) — Device 1. Steering shaft lower joint 2. The cover of the hole in the shield is not uncommon 3. Seals 4. Coupling 5. Steering gear with tie rods 6. Steering gear support 7....
Power Steering (Model PR24AC) — Adjustment Adjust the drive gear torque as follows. 1. Place rack in neutral position with no fluid in steering gear. 2. Screw in the adjusting screw, having previously applied a...
Power steering pump parts 1. Drive pulley 2. Retaining ring 3. Drive shaft 4. Oil seal 5. Suction pipe 6. O-ring 7. Spring 8. Flow valve 9. O-ring 10. Connector 11. Copper washer 12. Hose 13....