Brake system of the car Nissan Almera 1
General instructions for repairing the brake system
Recommended brake fluid is DOT 3 or DOT4. Never reuse drained brake fluid. Do not mix different types of brake fluids (DOT3 and DOT 4). Avoid contact of brake fluid with...
Recommended brake fluid is DOT 3 or DOT4. Never reuse drained brake fluid. Do not mix different types of brake fluids (DOT3 and DOT 4). Avoid contact of brake fluid with...
Standard tools and accessories
Torque wrench (2) with socket head (1) for removing and installing brake pipes (analogue of special key GG94310000) a: 10 mm Brake fluid pressure gauge
Torque wrench (2) with socket head (1) for removing and installing brake pipes (analogue of special key GG94310000) a: 10 mm Brake fluid pressure gauge
Brake system maintenance
Checking the fluid level The fluid level in the master cylinder reservoir should be between the MAX and MIN marks. If the fluid level drops significantly, check the...
Checking the fluid level The fluid level in the master cylinder reservoir should be between the MAX and MIN marks. If the fluid level drops significantly, check the...
Removal air from the hydraulic drive
WARNINGS: While bleeding, constantly monitor the fluid level in the tank. If there is a suspicion that air has entered the master cylinder, first bleed the air from the...
WARNINGS: While bleeding, constantly monitor the fluid level in the tank. If there is a suspicion that air has entered the master cylinder, first bleed the air from the...
Hydraulic system — disconnecting and connecting
Hydraulic system diagram Disconnection WARNING: Avoid excessive bending, twisting or stretching of brake hoses. 1. Place vinyl tubes over the air release valves. 2....
Hydraulic system diagram Disconnection WARNING: Avoid excessive bending, twisting or stretching of brake hoses. 1. Place vinyl tubes over the air release valves. 2....
Pressure regulator — checking, removal and installation
Examination WARNINGS: When measuring the pressure, press the brake pedal slowly. For ABS models, disconnect the connector from the actuator relay before checking. 1....
Examination WARNINGS: When measuring the pressure, press the brake pedal slowly. For ABS models, disconnect the connector from the actuator relay before checking. 1....
Brake pedal — removal, installation and adjustment
Removal and installation Examination Check the pedal and bracket for the following defects: Pedal bend Axial pin deformation Cracks in weld seams Cracks and deformations...
Removal and installation Examination Check the pedal and bracket for the following defects: Pedal bend Axial pin deformation Cracks in weld seams Cracks and deformations...
Master Brake Cylinder — Removal, Disassembly and Inspection
Removal WARNING: If fluid leaks from the master cylinder, disassemble it and check the piston seals for deformation or scoring. Replace defective parts. 1. Place vinyl...
Removal WARNING: If fluid leaks from the master cylinder, disassemble it and check the piston seals for deformation or scoring. Replace defective parts. 1. Place vinyl...
Brake Drive Booster
On-car checks Functional check. Press the brake pedal several times with the engine stopped to equalize the pressure in the booster cavities. Make sure that the pedal...
On-car checks Functional check. Press the brake pedal several times with the engine stopped to equalize the pressure in the booster cavities. Make sure that the pedal...
Vacuum hose and valve
Removal and installation WARNINGS: Avoid contact of oils and greases with the vacuum hose and valve. Place the hose on the fittings as shown in the figure. When...
Removal and installation WARNINGS: Avoid contact of oils and greases with the vacuum hose and valve. Place the hose on the fittings as shown in the figure. When...
Front disc brake mechanism
Replacing brake pads WARNINGS: Do not press the brake pedal with the cylinder body open, otherwise the piston will come out. Be careful not to damage the piston seal and...
Replacing brake pads WARNINGS: Do not press the brake pedal with the cylinder body open, otherwise the piston will come out. Be careful not to damage the piston seal and...
Rear drum brake mechanism
1. Wheel cylinder 2. Protective cap 3. Piston 4. Piston cuff 5. Cylinder body 6. Spring 7. Tension spring 8. Regulator 9. Brake shoe 10. Regulator lever 11. Regulator...
1. Wheel cylinder 2. Protective cap 3. Piston 4. Piston cuff 5. Cylinder body 6. Spring 7. Tension spring 8. Regulator 9. Brake shoe 10. Regulator lever 11. Regulator...
Rear disc brake mechanism
1. Cable guide 2. Support 3. Brake shoe manual lever 4. Guide fingers 5. Protective covers for guide pins 6. Shoe guide 7. Holder 8. Inner lining 9. Inner brake shoe 10....
1. Cable guide 2. Support 3. Brake shoe manual lever 4. Guide fingers 5. Protective covers for guide pins 6. Shoe guide 7. Holder 8. Inner lining 9. Inner brake shoe 10....
Parking brake actuator
Removal and installation 1. To remove the parking brake cable, first remove the center console. 2. Disconnect the parking brake switch connector. 3. Loosen the bolts and...
Removal and installation 1. To remove the parking brake cable, first remove the center console. 2. Disconnect the parking brake switch connector. 3. Loosen the bolts and...
Vacuum pump (engine CD20E)
1. Back cover 2. Spacer sleeve 3. Vacuum pump 4. Vacuum hose 5. Copper washer 6. Connector 7. Valve 8. Oil outlet hose 9. Oil outlet hose 10. Hollow bolt 11. Gasket 12....
1. Back cover 2. Spacer sleeve 3. Vacuum pump 4. Vacuum hose 5. Copper washer 6. Connector 7. Valve 8. Oil outlet hose 9. Oil outlet hose 10. Hollow bolt 11. Gasket 12....
Anti-lock braking system (ABS)
At speeds below 10 km/h the anti-lock braking system does not work. After the ignition is turned on, the system performs a self-test, and the ABS indicator lights up for...
At speeds below 10 km/h the anti-lock braking system does not work. After the ignition is turned on, the system performs a self-test, and the ABS indicator lights up for...
This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Similar information for other Nissan models
➜ Chassis: Brake system Nissan Micra 3 (2002-2010, petrol)
➜ Chassis: Brake system Nissan Patrol 4 (1987-1997, petrol)
➜ Chassis: Brake system Nissan Primera 1 (1990-1996, petrol)
➜ Chassis: Brake system Nissan Maxima 4 (1994-1999)
➜ Chassis: Brake system Nissan Sunny 7 (1990-1998)
➜ Chassis: Brake system Nissan Serena 2 (1999-2005)
Link in different formats to this section
TEXTHTMLBB Code
- User manual
- Control devices
- Preparing to move
- Heating, air conditioning and audio
- Starting the engine and driving
- Maintenance
- Technical information
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Control system (gasoline)
- Control system (diesel)
- Power and exhaust system
- Transmission
- Clutch
- Manual gearbox
- Automatic gearbox
- Chassis
- Front suspension
- Rear suspension
- Steering
- Brake system
- Body
- Heating and air conditioning
- Safety system
- Body elements
- Electrical equipment
- Equipment and devices
- Power devices
Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.