General notes on rear suspension repairs The final tightening of the fasteners when installing the rubber parts of the suspension must be carried out on a fully equipped, unloaded car, standing on the ground....
Special and standard tools and fixtures Special tools and fixtures HT71780000 Suspension spring compressor ST35652000 Suspension strut fixing tool Standard Tools torque wrench (2) with cap head (1) for...
Rear suspension device 1. Suspension strut cap 2. Washer 3. Sleeve 4. Gasket 5. Upper suspension strut support 6. Spring seal 7. Sleeve 8. Stroke Buffer Cap 9. Stroke Buffer 10. Helical spring...
Checking suspension parts on a car General procedures Check the suspension parts for excessive play, wear and damage. Rock the rear wheels in a vertical plane to reveal increased play. Tighten all...
Wheel hub — removal and installation Removing WARNINGS: Before removing the hub, disconnect the ABS sensor and move it to the side. Otherwise, the wires of the sensor may be damaged, which will lead to its...
Removal and installation of a back suspension bracket WARNING: Before removing the rear suspension, disconnect the ABS sensor and move it to the side. Otherwise, the wires of the sensor may be damaged, which will lead to...
Beam, cross member and tie rod Disassembly Removal of the rear suspension assembly is described in the relevant section of this chapter . Disconnect the suspension cross member and tie rod from the...
Data for adjustments and control Rear wheel alignment * collapse -1°00' ± 45' Convergence A-B distance 10±4mm Corner 5° ± 21' * For a fully equipped but unladen vehicle.