The final tightening of the fasteners when installing rubber suspension parts must be carried out on a fully loaded, unloaded vehicle standing on the ground.
After installing the removed suspension parts, check and, if necessary, adjust the wheel alignment angles.
When removing and installing brake hoses, use a spanner.
When installing brake hoses, be sure to adhere to the specified tightening torques.
Do not place a jack under the trailing arms or rear suspension beam.
General notes on rear suspension repair (Nissan Almera N15)
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This article has been reviewed: Sofia Shapovalova
Similar information for other Nissan models
➜ Rear suspension — general description Nissan Murano 1 (2002-2007, petrol)
➜ Rear Axle and Suspension — General Information Nissan Patrol 4 (1987-1997, petrol)
➜ Car repair — rear suspension beam Nissan X-Trail 2 (2007-2013, petrol)
➜ General information about suspension and steering Nissan Maxima 4 (1994-1999)
➜ Procedure for performing adjustments — general notes Nissan Terrano 1 (1986-1995, petrol)
➜ Rear suspension design Nissan Primera 1 (1990-1996, petrol)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- User manual
- Control devices
- Preparing to move
- Heating, air conditioning and audio
- Starting the engine and driving
- Maintenance
- Technical information
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Control system (gasoline)
- Control system (diesel)
- Power and exhaust system
- Transmission
- Clutch
- Manual gearbox
- Automatic gearbox
- Chassis
- Front suspension
- Rear suspension
- Steering
- Brake system
- Body
- Heating and air conditioning
- Safety system
- Body elements
- Electrical equipment
- Equipment and devices
- Power devices
Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.