General car care To keep your car looking good, regular maintenance is essential. To preserve the paintwork of the body, it is necessary to wash the car as soon as possible in the...
Body protection against corrosion The most common factors that cause corrosion of the car body: 1. Accumulation of moisture-containing dust and dirt in body panels, cavities, recesses, etc. 2. Damage to...
Precautions when performing maintenance When inspecting or maintaining your vehicle, you must always follow the safety rules to avoid accidents and unforeseen machine breakdowns. The following are general and...
Engine cooling system At the factory, the engine cooling system is filled with a high quality, all-weather antifreeze solution. The solution contains anti-corrosion additives and does not...
Checking the engine oil level 1. Park the vehicle on level ground and apply the parking brake. 2. Let the engine run until it warms up to operating temperature. 3. Stop the engine. Wait a few minutes...
Engine oil change 1. Park the vehicle on level ground and set the parking brake. 2. Let the engine run until it warms up to operating temperature and shut it down. 3. Place a container...
Oil filter replacement Used oil filters should be disposed of in specially equipped places. It is recommended that the filter be replaced by a Nissan dealer. 1. Park the vehicle on level...
Fuel filter (for CD20 engines) Draining If the fuel filter warning light comes on while the engine is running "", then drain the water as follows: 1. Place a container under the fuel filter to drain...
Bleeding air from the fuel system In the event that the car was refueled in a completely empty fuel tank, it is necessary to remove air from the fuel system. 1. Manually move the piston of the low...
Automatic transmission fluid CAREFULLY! When working under the hood with the engine running, care must be taken to keep hands, clothing, hair and tools at a safe distance from fans, drive belts and...
Power steering fluid Check fluid level. The liquid level should be measured with a rod in the range "NOT" at liquid temperature 50-80°C or range "COLD" at a temperature of 0-30°C. ATTENTION!...
Brake and clutch fluid The liquid level is checked in the respective tanks. If the level is below the MIN·mark, or if the brake system warning light is on, add DOT 3 or DOT 4 fluid to the MAX...
Wiper and headlight cleaner fluid Wiper fluid Version A Add fluid when the wiper warning light comes on. To increase the effectiveness of the windshield wiper, add detergent to the water. In winter, add...
Accumulator battery Keep the surface of the battery clean and dry. Traces of corrosion should be removed with sodium bicarbonate solution. Make sure that the pole pins are always clean and...
Drive belts When checking the drive belts, be sure to turn off the ignition (key in position "OFF"). 1. Visually inspect each belt for signs of fraying, cuts, twisting, or loose...
Replacing spark plugs CAREFULLY! First of all, make sure the engine and ignition are off and the car is held securely in place by the parking brake. ATTENTION! To avoid damage to the...
Air filter Viscose paper filter The viscose filter cannot be cleaned and reused. Replace it according to the schedule given in chapter " Maintenance Schedule ". When replacing the...
Wiper blades 1) cleaning If paste or other sticky substances get on the windshield or brushes, the operation of the wiper deteriorates, and the brushes begin to rattle. To restore...
Checking the condition of the brakes Parking brake Periodically test the effectiveness of the parking brake by braking the machine on a steep slope with the parking brake alone. If the machine is not held...
Fuses Engine compartment If the electrical equipment stops working, then you should check the fuses. 1. Turn off the ignition and set the headlight switch to the position...
Lighting devices Headlights The headlight is an optical focusing element based on a replaceable halogen lamp. The headlight housing is sealed. The bulb is replaced from inside the engine...
Wheels and tires In the event of a flat tire, refer to the article " Flat tire ". Tire pressure Check tire pressure periodically (including spare wheel). Abnormal pressure reduces tire...
General maintenance This Nissan machine is designed to have minimum maintenance requirements and longer maintenance intervals to save the owner time and money. However, in order to maintain...
Periodic maintenance If the vehicle maintenance schedule is listed in another document, such as a warranty booklet, then follow it. The following tables list items that require periodic...
Maintenance program Abbreviations: 3 - Replacement; P - Check / adjustment; K - Control, cleaning, lubrication, topping up. TYPES OF WORK / mileage (thousand km) 15 30 45 60 75 90 105 120...
Vehicle lifting WARNINGS: Never work under a vehicle that is only supported by a jack. When not using a lift, be sure to place the vehicle on stands. When jacking up the vehicle, place...
Maintenance under severe operating conditions The maintenance intervals given in the previous tables are for normal operating conditions. If the vehicle is driven most of the time under the severe conditions listed...
Checking high voltage wires 1. Check the wires for cracks, damage and burnt contacts. Make sure they fit correctly. 2. Measure the wire resistance. Check for internal breaks in the wires, which are...
Checking the oxygen sensor !. Set diagnostic mode II and enter the oxygen sensor test procedure (see chapter « Engine management system »). 2. Maintain engine speed at 2000 rpm -1 for about 2...
Injector test (CD engine) 1. Disconnect the fuel supply pipes and the outlet pipe. 2. Unscrew the nozzles with a suitable wrench (27 mm). 3. Clean and inspect the nozzles. 4. Attach the nozzle to...
Idle speed check (CD20 engine) Preparation 1. Check injection start angle. 2. Check the condition of the injectors. 3. Check: air supply path (is the air filter clogged); preheating system; engine oil...
Checking manifold nuts (CD engines) 1. Remove the exhaust manifold cover. 2. Tighten the manifold mounting bolts and nuts. Tightening torque 18-22 Nm. Exhaust system check Inspect the exhaust pipes and...
Clutch test Checking the fluid level in the clutch release actuator If the fluid level in the reservoir drops significantly, check the hydraulic system for leaks. Hydraulic clutch...
Checking the oil level in the manual gearbox Check for leaks may be behind from the gearbox. Remove the speed sensor gear and measure the oil level (L) from the back with a suitable rod. Normal oil level (value L),...
Checking the Fluid Level in an Automatic Transmission 1. Warm up the engine. 2. Make sure there are no fluid leaks from the gearbox. 3. Before driving, the fluid level must be checked against the COLD marks on the dipstick...
Checking the level of brake fluid and brake system Checking the brake fluid level If the fluid level is too low, check the brake system for leaks. Checking the brake system Check the brake hoses and pipes, as well as the...
Checking disc brakes Brake disk Check its condition and residual thickness. Caliper Check for brake fluid leaks. Brake pads Check the wear of the brake pads and make sure that the pads are...
Checking drum brakes Wheel cylinder Check for brake fluid leaks from under the protective caps. Brake drum Check the condition of the inner surface. Nominal diameter: 180.0 mm Maximum...
Checking the steering gear and rods Steering gear Inspect the steering gear housing and protective covers. Cases must not be cracked or damaged. Check for grease leakage. Check steering gear to steering...
Power steering test Check the fluid level in the power steering reservoir with the engine stopped. To check the fluid level, use the dipstick on the tank lid or the marks on the tank. The...
Checking the seat belts WARNINGS: After any collision, check all angles associated with seat belts, including retractors and seat rails. Nissan recommends replacing as an assembly all of the...
Checking the condition of the body Check metal body panels for corrosion, paint damage (scratches, chips, abrasion, etc.) or damage to the anti-corrosion coating. In particular, check the following...