Clamps and latches Replace clips and retainers that have been damaged during removal.
Removal and installation of bumpers Removal and installation of a forward bumper The numbers of operations correspond to the numbers of fasteners in the figure. 1. Remove the front spoiler (not shown in...
Adjustment of hinges and locks Adjustment of hinges and locks is carried out in accordance with the figures below. The latches must be located strictly in the center of the locks. Hood, trunk lid (or...
External rear-view mirror — removal 1. Remove the door upholstery (see subsection « doors »). 2. Remove an overlay in a forward corner of a door. It is secured with three fasteners. 3. Disconnect an...
Removal of an upholstery of doors The operation numbers correspond to the part numbers in the figure. 1. Remove the inner handle cover. 2. Remove the power lift switch block by prying it out with a...
Instrument panel and center console Removing The operation numbers correspond to the part numbers in the figure. First disconnect the wires from the battery and the airbag connectors. Remove the driver...
Front seat For heated seats, be careful not to damage the heating elements. To replace the heating elements, the seat upholstery must be removed. Do not use organic solvents to...
Backseat The rear seat for the sedan is shown in the figure. In hatchback bodies, either a one-piece seat or a two-piece seat can be installed, each of which can be folded...
Rear combination lamps The lights are attached to the body and trunk lid with nuts and butyl glue. When installing the lanterns, it is necessary to evenly apply a layer of glue (usually at the...
Side moldings Vehicles covered with Hard Clear Coal use 3M No. 4210 or equivalent. Before gluing the moldings, it is necessary to apply a layer of primer 3M No. N-200, S-100 or...
Removal and installation of wind and rear windows The glass is separated from the body after the seal is removed. The fastening of the upper windshield seal, the upper and side rear window seals in the sedan body is the...
Installation of side windows Gluing side windows in xztchback bodies is carried out in accordance with the figures below. 5 door hatchback 3 door hatchback