Table of contents: Removal and installation the front…↓ Removal and installation the rear…↓
Removal and installation the front bumper
The operation numbers correspond to the fastener numbers in the figure.
1. Remove the front spoiler (not shown in the picture), which is attached with one screw from below:
2. Remove the bolts securing the bumper to the lower engine splash guard.
3. Remove the CG101 clips securing the radiator grille trim.
4. Remove the direction indicators by unscrewing the mounting screws.
5. Loosen the screws and remove the CS101 clamps (for standard bumpers) or CS205 (yatya bumpers with air intakes), securing the right and left edges of the front wing trim.
6. Unscrew the bolts securing the bumper to the fenders.
7. Loosen the bolts and remove the CS101 clamps securing the bumper to the holder.
8. Remove the bumper forward.
If fog lights are installed, remove them before removing the bumper.
Installation is carried out in reverse order.
Removal and installation the rear bumper
1. Unscrew the bolts securing the bumper to the fenders.
2. Loosen the bolts and remove the CS101 clamps securing the bumper from below.
3. Remove the CS101 clamps (CS205 for hatchback body), securing the bumper to the rear panel of the body.
4. Remove the bumper back.
Installation is carried out in reverse order.