The operation numbers correspond to the part numbers in the figure.
1. Remove the inner handle cover.
2. Remove the power lift switch block by prying it out with a flathead screwdriver and disconnect the connector. In the front door of models up to 04.96, it is necessary to remove the armrest trim along with the switch block (The cover is attached with four latches).
3. Remove the screw securing the armrest handle and remove the handle.
4. Remove the power window handle (in models with manual windows: not shown in the figure). To do this, press the screwdriver on the clamp and remove the handle from the shaft. Install the handle with the glass fully raised in the position shown in the figure.
5. Turn out screws and remove C103 clamps fastening an upholstery of a door.
6. Remove the door upholstery by lifting it up.