2. Loosen the screws securing the armrest to the panel.
3. Remove the window lift handle by using a thin, curved tool to remove the spring ring.
To do this, press the decorative cover to gain access to the shaft and the spring ring, pry the ring and move it towards the handle, and remove the ring. Remove the handle and plastic washer.
4. Remove the door lock handle.
5. Remove the decorative door handle shield (photo).
14.5 To remove the handle shield, unscrew one screw
6. Use a screwdriver to pry up and remove the panel latches from the door frame (photo). Start removing the latches from the bottom and move upward, removing the latches along the contour of the panel. Lift and remove the panel.
14.6 Inner door panel fastening latches
7. Before installation, check the condition of all latches and ensure that the waterproof screen is oriented correctly.
8. Install the panel, using the inserted window lift handle as a guide.
9. Insert the latches into the holes in the door frame (by hand or with a plastic hammer).
10. Then install in reverse order. Secure the window lift handle with a spring ring. To do this, insert the spring ring into the groove on the handle so that the ring gap is facing 180° from the handle, set the handle parallel to the handle on the opposite door and push the ring until it clicks.