Table of contents: Preparing for installation of…↓ Preparing for installation of the…↓
The glass is separated from the body after removing the seal. The fastening of the upper windshield seal, the upper and side seals of the rear window in the sedan body is made the same (see picture). The side windshield seals and the lower rear window seal in the sedan body are secured with screws.
To separate the glass, it is necessary to cut the adhesive seam around the perimeter.
To install the glass, use the genuine Nissan Sealant kit or equivalent. Follow the instructions included with the kit.
Preparing for installation of windshield and rear glass
1. Install stops on the lower edge of the window opening.
2. Install the seal clamps on the adhesive tape. Before installation, heat the body and clamp to approximately 30-40°C.
3. Stick a rubber gasket around the perimeter of the glass at a distance of 8 mm from the edge. The joint of the gasket should be in the center of the lower edge of the glass.
(Material borrowed from the website: NISSANBOOK.ru)
Preparing for installation of the rear door glass
1. Install spacers in the designated locations.
2. Apply primer to the body,
3. Apply sealant to the glass.
4. Apply primer to the glass.
5. Apply glue evenly.
