Table of contents: Removal ↓ Installation ↓
1. Rear door window glass molding; 2. Rear door window glass; 3. Clamp; 4. Spacer; 5. Sealant; 6. Primer; 7. Rear door outer panel
Removal
1. Remove the trim from the inside of the rear door. See section "Exterior finishing".
2. Remove the rear window wiper arm. See chapter Electrical equipment.
3. To avoid damaging painted surfaces, apply protective tape around the perimeter of the rear door window glass.
(The text was copied from the portal www.NISSANBOOK.ru)
4. After removing the molding, remove the glass using a knife or electric cutter and an inflatable bag.
Note: If reinstalling the rear door window glass, mark the body and glass.
Attention:
- When cutting glass from a car, wear safety glasses and thick gloves to prevent glass fragments from getting into your eyes or injuring your hands.
- If you are reusing the rear door window glass, do not use a knife or power cutter.
- Be careful not to scratch the glass during removal.
- Do not stand the glass on its end. Small chips can turn into cracks.
5. Remove the rear door window glass using suction cups.
Installation
Use a genuine Nissan urethane adhesive kit or equivalent and follow the instructions included with it.
The installation method and precautions are the same as for the windshield.