Vehicle heating and ventilation Nissan Micra 3 (K12)
General information about the heating and ventilation system
Description of systems Description of the ventilation system control with heater and air conditioning is given in Chapter Controls and operating techniques . The coolant...
Description of systems Description of the ventilation system control with heater and air conditioning is given in Chapter Controls and operating techniques . The coolant...
Correcting the refrigerant level
When replacing components other than the compressor 1. To adjust the amount of refrigerant after replacing the evaporator, condenser or receiver-dryer, add compressor...
When replacing components other than the compressor 1. To adjust the amount of refrigerant after replacing the evaporator, condenser or receiver-dryer, add compressor...
Removal, installation, disassembly and assembly of the ventilation system control unit with heater and air conditioning
Assembly of the control unit of models without automatic K/V 1 - Rear window heating switch; 2 - K/V switch; 3 - Air distribution mode switch handle; 4 - Fan speed...
Assembly of the control unit of models without automatic K/V 1 - Rear window heating switch; 2 - K/V switch; 3 - Air distribution mode switch handle; 4 - Fan speed...
Removal, installation, assembly and disassembly of the K/V unit
Fastening of the K/V block Assembly of the K/V block of models with manual control 1*,5,11,13,23 - Screw; 2* - Aspirator line; 3/15 - Right/Left Fan Shroud; 4/14 -...
Fastening of the K/V block Assembly of the K/V block of models with manual control 1*,5,11,13,23 - Screw; 2* - Aspirator line; 3/15 - Right/Left Fan Shroud; 4/14 -...
Removal and installation the heater radiator
Note: The components listed in the description are shown in the illustration Assembly of the K/V block of models with manual control . 1. Remove the A/C unit (see...
Note: The components listed in the description are shown in the illustration Assembly of the K/V block of models with manual control . 1. Remove the A/C unit (see...
Removal and installation the heater fan electric motor
1. Remove the instrument panel (see Chapter Body ). 2. Remove the left side air duct. 3. On models with/without automatic A/C, disconnect the fan wiring connector or...
1. Remove the instrument panel (see Chapter Body ). 2. Remove the left side air duct. 3. On models with/without automatic A/C, disconnect the fan wiring connector or...
Removal and installation of the fan resistor assembly and the A/C system sensors
1. To gain access to the resistor assembly, remove the glove box assembly (see Chapter Body Remove the two screws (No. 31 in the illustration) Assembly of the K/V block...
1. To gain access to the resistor assembly, remove the glove box assembly (see Chapter Body Remove the two screws (No. 31 in the illustration) Assembly of the K/V block...
Adjusting the damper drive cables
Note: Dampers, cables and their installation components are shown in the illustration Assembly of the K/V block of models with manual control . Cable drive is used only...
Note: Dampers, cables and their installation components are shown in the illustration Assembly of the K/V block of models with manual control . Cable drive is used only...
Removal and installation of electric motors for damper drives
Note: Electric motors are used only on models with automatic c/v (see illustration Assembly of the K/V block of models with manual control ). 1. To remove the damper...
Note: Electric motors are used only on models with automatic c/v (see illustration Assembly of the K/V block of models with manual control ). 1. To remove the damper...
Removal and installation of air ducts and deflectors
Air ducts and deflectors 1, 4 - Side deflectors; 2, 3 - Central deflectors; 5 - Assembling the instrument panel; 6, 10 - Side air ducts; 7, 9 - Air ducts for blowing...
Air ducts and deflectors 1, 4 - Side deflectors; 2, 3 - Central deflectors; 5 - Assembling the instrument panel; 6, 10 - Side air ducts; 7, 9 - Air ducts for blowing...
Removal and installation of refrigerant lines and A/C compressor
Refrigerant line connections 1. Before disconnecting the refrigerant lines, discharge the A/C system in a qualified workshop. 2. The refrigerant line connections are...
Refrigerant line connections 1. Before disconnecting the refrigerant lines, discharge the A/C system in a qualified workshop. 2. The refrigerant line connections are...
Removal and installation of other components of the air conditioning system
1. Before disconnecting refrigerant lines, discharge the A/C system in a specialized workshop. After removing hoses and tubes, plug any open holes; replace the sealing...
1. Before disconnecting refrigerant lines, discharge the A/C system in a specialized workshop. After removing hoses and tubes, plug any open holes; replace the sealing...
Automatic CV self-diagnosis
Code 41 42 43 44 45 46 Mode flap Feed flap Circulation Supply ventilation Mixing flap Cooling 50% Heating Voltage on the heater fan, V 5 10.5 8.5 8.5 8.5 12 Compressor...
Code 41 42 43 44 45 46 Mode flap Feed flap Circulation Supply ventilation Mixing flap Cooling 50% Heating Voltage on the heater fan, V 5 10.5 8.5 8.5 8.5 12 Compressor...
This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Similar information for other Nissan models
➜ User manual: Heating, air conditioning and audio Nissan Almera 1 (1995-2000)
➜ Body: Heating and air conditioning Nissan Serena 2 (1999-2005)
➜ Body: Heating and air conditioning Nissan Qashqai 1 (2006-2013)
➜ Body: Heating and air conditioning Nissan Bluebird T12 (1986-1991)
➜ Power unit: Heating and ventilation Nissan Sunny 7 (1990-1998)
Link in different formats to this section
TEXTHTMLBB Code
- User manual
- Control devices
- Preparing to move
- Starting engine and driving
- Maintenance
- Technical information
- Power unit
- Engine repair CR
- Engine repair HR
- Engine lubrication system
- Cooling system (CR)
- Cooling system (HR)
- Fuel and exhaust system
- Engine management (CR)
- Engine management (HR)
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Drive shafts and axles
- Chassis
- Car suspension
- Brake system
- Steering
- Body
- Airbags (SRS)
- Doors, hood and locks
- Glasses and mirrors
- Exterior (external elements)
- Interior (internal elements)
- Air conditioning automatic
- Electrical equipment
- Equipment and devices
- Launch and charge system
- Headlights and lighting
- Windshield wipers and washers
- General information
- Introduction to guide
- Governing bodies
- Starting engine and driving
- Maintenance
- Power unit
- Engine repair
- Cooling system
- Heating and ventilation
- Power and exhaust system
- Ignition system
- Charge and launch systems
- Transmission
- Mechanical gearbox
- Automatic gearbox
- Clutch
- Drive shafts and hubs
- Chassis
- Brake system
- Car suspension
- Steering
- Body
- Exterior (external elements)
- Interior (internal elements)
- Electrical equipment
- Equipment and devices
- Electrical circuits
Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.