Brake pedal — check and adjustment Free travel and clearance between the brake pedal and the floor panel when the pedal is depressed Check the free play of the brake pedal. Check the height from the brake...
Brake pedal — removal and installation Components 1. Cotter pin; 2. The switch of lanterns of a stoplight; 3. Clamp; 4. Brake pedal assembly; 5. Pin Attention: Do not deform the brake pipe. When removing and...
Brake Fluid — Level Check Make sure the fluid level in the reservoir is correct (between marks «MAX» And «MIN»). Visually check for fluid leaks around the reservoir. If the fluid level is...
Brake Fluid — Check Brake Lines Caution: If fittings are leaking, tighten or replace damaged components as needed. 1. Check the brake pipes and hoses for cracks, wear or other damage. Replace damaged...
Brake Fluid — Draining and Refilling Attention: Fill with fresh Nissan Genuine Brake Fluid or «DOT 3» or «DOT 4» (US FMVSS No.116). Do not mix different brands of brake fluid («DOT 3», «DOT 4»). Do not...
Bleeding the brake system Attention: While bleeding, keep an eye on the brake fluid level in the master cylinder. Fill with fresh Nissan Genuine Brake Fluid or «DOT 3» or «DOT 4» (US FMVSS...
Master brake cylinder — removal and installation Removing 1. Drain the brake fluid. See section « Drain and refill ». 2. Disconnect the wiring connector from the brake fluid level sensor. 3. Disconnect the hose from...
Vacuum brake booster — removal and installation Removing Attention: Do not deform or bend the brake pipes when removing and installing the brake booster. Replace pin if damaged. Do not damage the threads of the brake...
Vacuum tubes and hoses — removal and installation Vacuum hose Attention: Since a stop valve is built into the vacuum hose, it must be installed in the correct direction. Follow the label. If the hose is connected...
Front wheel disc brakes — check on the car Checking pad wear Check the thickness of the pads through the inspection hole in the cylinder body. Use a ruler if necessary (see fig.). Standard Thickness: 12.4mm Limit...
Rear wheel drum brakes — checking the working cylinder Check for wear, rust and damage on the piston, cuffs and on the inner walls of the cylinder. Replace if necessary. Caution: Do not scratch the cylinder when installing...
Parking brake — check and service on the car Lever stroke Tighten the lever with a force of 196 N (20 kg) and check (by the sound of the ratchet), whether the number of clicks is normal. Number of clicks: 8-9
Parking brake — adjustment 1. Insert a wrench with a long head into the hole in the parking brake lever. Turning the adjusting nut (1) fully loosen the cable (2), then release the parking brake...
Parking brake — removal and installation Removing 1. Remove the center console. See chapter Body . 2. Disconnect a socket from the switch of a control lamp. 3. Loosen the adjusting nut and separate the rear...
Wheel sensors — removal and installation Removing When removing wheel sensors, pay attention to the following: Attention: When removing the sensor, do not rotate it if possible. Do not pull hard on the sensor...
Sensor ring — removal and installation Front Since the sensor ring is structurally integral with the wheel bearing, change it together with the bearing. See chapter Front axle and suspension . Behind When...
ABS actuator and control unit — removal and installation Removing When removing, pay attention to the following: Attention: Disconnect the cables from the battery before servicing. In order not to damage the union nuts and the...