Automatic transmission specifications Specifications Type and model of AT 4-speed, RE4F03B AT assembly code On models with CR12DE engine 3AX80 On models with CR14DE engine 3AX81 Type and volume of ATF cm....
Automatic transmission design AT in section 1 - Reinforcing piston of the tape; 2 - High gear clutch; 3 - Torque converter housing; 4 - Brake tape; 5 - Reverse gear clutch; 6 - Oil pump; 7 - Torque...
Troubleshooting Automatic Transmission If a AT malfunction is detected, first of all check the ATF level (see chapter Vehicle settings and routine maintenance ). If the level is insufficient, check the...
Selector cable adjustment 1. Loosen the locknut securing the cable to the hand plate so that the cable can move freely. 2. Set the plate and selector lever to position «P». Note. Turn the wheels...
Removal and installation of the PNP sensor 1. Remove the selector cable from the hand plate (see Section Selector cable adjustment ). 2. Set the plate to position «N». 3. Turn out three bolts and remove the PNP...
Replacing the speed sensor 1. Remove drive shafts (see chapter Drive shafts, steering knuckles and hub assemblies ). 2. Remove the square. 3. Remove the speed sensor. 4. Install transducer, square...
Removal and installation of automatic transmission Removing AT mounting components 1. Remove the battery (see chapter Engine Electrical Systems ) and air duct (see chapter Power supply and exhaust systems ). 2. Remove...
Automatic transmission repair AT repair associated with its disassembly should be entrusted to specialists. AT assembly components are shown in the illustrations below. Torque converter and oil pump...