Car automatic transmission Nissan Maxima 4 (A32)

General information about automatic transmission
This Part of the Chapter is devoted to automatic transmission. Due to the complexity of the AT design, the lack of commercially available replacement internal...

AT/CVT Failure Diagnostics — General Information
AT failures most often occur for one of the following five reasons: a) Reduced engine output efficiency; b) Violation of regulations; c) Hydraulic failure; d) Mechanical...

Checking, adjusting and replacing the gear shift cable
Move the selector lever from position "P" to position "1" - when passing each of the ranges, you should feel the click of the corresponding lock. If the locks do not...

Removal and installation the AT selector lever
Warning! Some models covered in this Manual are equipped with airbags - always turn off the SRS when servicing components located near the airbags (see Chapter On-board...

Transmission Shift Lock System
Warning! Some models covered in this Manual are equipped with airbags - always turn off the SRS when servicing components located near the airbags (see Chapter On-board...

Checking, replacing and adjusting the starter enable switch sensor
The presence of this switch-sensor ensures the possibility of starting the engine only in two transmission positions: "P" and "N". If the engine is started in any...

Removal and installation of automatic transmission
Note: The transmission mounting bolts are of different lengths, are not interchangeable and must be screwed into their original locations during installation. 1. Remove...

Overhaul of automatic transmission
AT RE4F02A Internal Components Layout Diagram Tightening force of threaded connections, Nm: A: 44 ÷ 5 B: 6.3 ÷ 8.3 C and N: See subsection "Assembly" D: 20 ÷ 26 E: 5 ÷ 7...