Automatic transmission — general information The vehicles described in this manual are equipped with a RE4R03A 4-speed automatic transmission with electronic control and a rotation converter that locks up when the...
Checking and Adding Transmission Fluid Note. Use only the recommended grade of hydraulic fluid to add and charge AT (see tables of sizes and adjustments at the end of the guide). The transmission fluid level...
Transmission Fluid Replacement 1. Warm up the transmission to normal operating temperature, jack up the vehicle and place it on jack stands so that the transmission oil pan is horizontal. 2. Install a...
Maintenance of the start enable switch Functional check 1. Disconnect the negative cable from the battery. 2. Disunite an electric socket of the gauge switch of permission to start. 3. Check for continuity...
Selector rod adjustment 1. Set the selector lever to position "R". 2. Working under the vehicle, loosen the selector rod locknut. Make sure the selector rod on the transmission is in position...
Servicing the Power Switch Models of the early years of production (with carburetor distances 4.2 l and 3.0 l) 1. Disconnect the negative cable from the battery. 2. Using a small screwdriver,...
Overdrive Select Switch Service (4.2L EFI Models) 1. Using a small screwdriver, carefully remove the switch from the front of the selector lever handle (see accompanying illustration). 2. Loosen the screw and remove the...
Removal and installation of transmission Note. To perform the procedures described below, you will need a special throne jack. Attention! Attempting to remove the transmission without using a special jack can...
Brake Band Adjustment (4.2L EFI Models) Note. Adjustment of AT brake bands is not a standard service procedure and is not normally required under normal conditions. The occurrence of such a need indicates the...