Removal and installation of the fuel filter The procedures for removing and installing the fuel filter are described in detail in the relevant Section of the Head Settings and ongoing maintenance . If the fuel...
Carburetor maintenance Removing 1. Disconnect the negative cable from the battery. 2. Remove the air cleaner assembly from the carburetor. 3. Disconnect the fuel supply hose from the...
Fuel pump service Note. The following procedures require a suitable fuel pressure gauge (manometer) and a three way fitting. Models 3.0 l Fuel pressure check Note. It is important that...
Fuel Return Solenoid Valve Service (3.0L Models) Function test 1. Disconnect the hose from the fuel return pipe and lower its end into the prepared container. Seal the open end of the tubing to prevent dirt from...
Maintenance of the throttle drive cable Removing 1. Loosen the locknuts and remove the cable from the adjustment bracket. 2. Turn the lever to move the throttle to the fully open position. Using the resulting...
Servicing the Hand Throttle Cable Removing 1. Loosen the locking tabs and remove the plastic throttle cable bushing from the top of the throttle lever. Release the cable from the lever. 2. Give...
Fuel tank service Note. The procedures described below apply to Station Wagon and Hardtop models. For other types of bodies, work is carried out similarly with the necessary amendments to...
Maintenance of the fuel injection system Note. The following procedures require a pressure gauge with a range of up to 600 kPa, a suitable three-way fitting, and hoses. Attention! Before disconnecting any...
Servicing the Air Suction System Removal, installation and maintenance of the air cleaner filter element Element Maintenance The procedure is described in detail in Chapter Settings and ongoing...
Exhaust system — general information Due to the many design modifications of exhaust systems, it is not possible and appropriate to consider in detail all of them in one Guide. The removal and installation...