Gasoline engine 3.0 liter car Nissan Patrol 4 (Y60)
General information about 3.0L engines The engine belongs to the 6-cylinder in-line units with an overhead camshaft (ohc), cross-flow aluminum alloy cylinder head and cast iron crankcase. The crankshaft is...
Removal and installation of the engine Note. Reliable lifting equipment with approved rigging will be required to perform engine removal and installation procedures. Removing 1. Raise the hood and take care...
Removal and installation of the inlet pipeline Removing The component layout in the accompanying illustration will make it easier to follow the procedures described below. The air cleaner in the illustration has been...
Removal and installation of a final collector Removing 1. Disconnect the negative cable from the battery. 2. Working under the car, give bolts of fastening of a reception pipe of system of release of the fulfilled...
Servicing the cylinder head and camshaft Note. The following special equipment is required to perform the procedures below: valve spring compression tool, micrometer, plunger-type dial gauge, and flatness gauge...
Oil pump service Removal and disassembly 1. Remove the timing belt. 2. Remove the gear and rear guide plate from the crankshaft. Note. To prevent damage to the oil pump/crankshaft seal...
Replacing the crankshaft seals Note. A puller is required to perform the work described below (to remove the crankshaft pulley). Front oil seal 1. Disconnect the negative cable from the battery. 2....
Servicing the crankshaft and main bearings Note. You will need a puller to perform the procedures below (to remove the crankshaft gear), micrometer and plunger-type dial gauge. Removing 1. With the engine removed...
Flywheel maintenance Note. The procedures below require a plunger-type dial meter and a heat source (e.g. blowtorch). Note. To gain access to the flywheel, the engine or transmission must be...
Removal and installation of supports of the power unit Powertrain Front and Rear Mount Components 1 - bolts; 2 - supports (pillows); 3 - nuts 4 - cross beam; 5 - brackets; 6 - shield Front supports Removing 1. Jack up the...