Transfer case — general information Carburetor models 4.2 l and 3.0 l All models are equipped with a TX12A transfer case mounted at the rear of the transmission and allowing the driver to directly drive...
Removal and installation of the transfer case Note. You will need the following special tools to complete the procedures below: 30mm replacement socket (for removing the front drive flange); head 32 mm (for removing...
Transfer case disassembly Note. When removing the components of the transfer case, mark for yourself their installation position - this will greatly facilitate subsequent assembly. 1. Give a...
Checking the status of internal components 1. Wash all components with solvent and dry with compressed air. Make sure that all traces of the old sealant are completely removed from the mating surfaces of the...
Transfer case assembly Installation is carried out in the reverse order of dismantling. 1. Using a suitable drift, seat the oil seals into the rear and center crankcases and the input shaft...
Cardan shafts — general information Cardan shafts are double tubular sleeves equipped with universal (cardan) hinges with flanges on the outer holders of the crosses at both ends of the shaft. (see...
Removal and installation — cardan shafts Removing 1. Jack up the car and put it on stands. 2. Mark the position of the flanges of the front and rear propeller shafts relative to the flanges of the final drive...
Replacement of cardan joints Note. Maintenance of cardan joints is carried out in a complex. The repair kit includes a cross, four needle roller bearings with cups, oil seals and circlips. It is not...