Brake system — general information The functioning of the brake system is controlled by a dual-circuit master brake cylinder (GTZ) double type, articulated with a vacuum booster (servo drive unit) brakes....
Maintenance of the main brake cylinder (GTZ) Removal and installation 1. Cover the right front mudguard with a protective cover. The location of the GTZ and related components in the engine compartment of the...
Servicing front disc brakes Note. You will need the following special tools to perform the procedures below: Dial meter (to check the amount of disc runout), vernier caliper (for measuring disc...
Servicing rear drum brakes Removal and disassembly 1. Jack up the rear of the vehicle and place it on jack stands. Block both front wheels with wedges. 2. Remove the rear wheel and brake drum. 3....
Maintenance of rear disc brakes Note. You will need the following special tools to perform the procedures below: Dial meter (to check disc runout); vernier caliper (for measuring the residual thickness...
Bleeding the hydraulic system The need to pump the hydraulic path arises only when the hydraulic lines were disconnected or when the brake fluid was drained, air entered the system. Brake hydraulic...
Servicing the brake pedal Removing 1. Remove the mounting clip, squeeze the plastic locking tabs, remove the pin and disconnect the pusher from the brake pedal. 2. Try to remember the...
Removal and installation of the pressure regulator valve Removing 1. Jack up the rear of the vehicle and place it on jack stands. 2. Disconnect the drive spring from the valve (the location of the valve - pressure regulator is...
Parking brake maintenance Removal and installation of shoes of the parking brake mechanism Removing 1. Jack up the rear of the vehicle and place it on jack stands. 2. Remove the cardan shaft from...