Engine Specifications General information and technical data Designations of engines, their maximum power CR10DE 1.0 l, 65 hp @ 5600 rpm CR12DE 1.2 l, 65 hp @ 5200 rpm CR12DE 1.2 l, 80 hp @...
General information and preparatory operations General information This chapter describes the most common and important engine maintenance and repair procedures, with the exception of those requiring special skills...
Compression pressure test Note. An assistant will be required to check the compression pressure. Compression pressure measurement provides an overview of the current condition of internal engine...
Checking the engine with a vacuum gauge Using a vacuum gauge, you can get information about the condition of the engine and determine that the cylinder head gasket is broken, the power system, piston rings or...
Engine Oil Pressure Check 1. To check, a pressure gauge is required, which can be screwed into the oil pressure port D / V located above the fuel filter. 2. Check and, if necessary, correct the...
Removal and installation of the inlet pipeline Components of fastening of the inlet pipeline 1 - Support bracket; 2 - Gasket; 3 - Hairpin; 4 - Inlet pipeline 1. Remove the air intake sleeve and air cleaner cover...
Removal and installation of the oil pan and oil intake Note. The removal and installation of the top section of the oil pan requires the removal and installation of the transmission. Components for fastening the oil pan and...
Removal, check and installation of camshafts Camshaft Installation Components 1 - Upper bearings No. 2-5 camshafts; 2 - Upper support No. 1 of camshafts; 3/4 - Inlet / outlet camshaft; 5 - Valve lifters; 6/7 -...
Checking and adjusting valve clearances Note. Valve clearances should be checked after removal and installation of camshafts, valve components, as well as symptoms indicating a violation of the gaps (e.g. at...
Removal and installation of the timing chain Timing Chain Installation Components 1 - Front cover of the cylinder head; 2/3 - Intake / exhaust camshaft sprocket; 4 - Timing chain tensioner; 5 - Timing chain...
Removal and installation of crankshaft oil seals 1. You can replace the front oil seal as if the front cover of the cylinder block was removed (see Section Removal and installation of the timing chain ), as well as...
Removal and installation of the power unit Powertrain Mounting Components 1 - Pillow of the left support; 2/3 - Bracket left support (body/transmission side); 4 - Rack of the right support; 5 - Pillow of the...
Oil pump service Oil pump installation and assembly components 1 - Front cover of the cylinder block; 2 - Inner rotor; 3 - Outer rotor; 4 - Oil pump cover 1. The oil pump is built into...
Dismantling and assembly of the block of cylinders Note. Because disassembly and assembly of the cylinder block are typical procedures for all vehicles, only illustrations are given explaining the assembly of the block,...