Cooling System — Location of Components 1. Central air duct blowing the windshield; 2. Side air duct blowing the windshield; 3. Side! ventilation duct; 4. Air conditioning assembly; 5. Central ventilation...
Self-diagnostic function — description The system is intended for diagnosing sensors of damper motors, blower motor, etc. through the system wiring. Switching from normal control mode to self-diagnostic mode:...
Ambient temperature sensor — removal and installation Removing 1. Remove the grille (From the left side). See chapter Body . 2. Disconnect the connector from the sensor (1) and take it off. Installation Installation is...
Cabin air temperature sensor — removal and installation Removing 1. Remove the bottom trim of the dashboard. See chapter Body . 2. Remove the fixing screw (A) and remove the sensor (1) from the lower trim of the dashboard...
Sunlight intensity sensor — removal and installation Removing 1. Remove the dashboard top mask. See chapter Body . 2. Disconnect the connector from the sensor (1) and take it off. Installation Installation is basically...
Intake air temperature sensor — removal and installation Removing 1. Remove the evaporator. Caution: Seal or wrap the fitting with a suitable material, such as vinyl tape, to prevent air from entering. 2. Remove the intake air...
Air conditioning assembly — removal and installation Removing 1. Discharge the refrigerant from the air conditioner to the recovery/recovery unit (for HFC-134a) 2. Drain the coolant from the cooling system. See chapter...
Air conditioner assembly — disassembly and assembly 1. Central air duct blowing the windshield; 2. Rubber bushing; 3. Housing intake dampers; 4. Insulator; 5. Nut; 6. Blower fan motor; 7. Air conditioner filter; 8....
Supercharger engine — removal and installation Removing 1. Remove the dashboard and overlays. See chapter Body . 2. Remove the side ventilation duct. 3. Disconnect the connector (1) from the blower motor. 4. Press on...
Intake damper motor — removal and installation Removing 1. Remove the lower dashboard trim and lower dashboard cover (left). See chapter Body . 2. Disconnect the connector (A). 3. Remove the fixing screws (IN) and...
Mixing damper motor — removal and installation Removing 1. Remove the bottom trim of the dashboard. See chapter Body . 2. Remove the console box assembly. See chapter Body . 3. Loosen the fixing nuts (A), remove the...
Blower damper motor — removal and installation Removing 1. Remove the glove box assembly and lower instrument panel cover (right). See chapter Body . 2. Remove the fixing screws (A) and remove the blower damper motor...
Power transistor — removal and installation Removing 1. Remove the air conditioner assembly. 2. Remove the fixing screws (A) and remove the power transistor (1). Installation Installation is basically done in the...
Heater core — removal and installation Removing 1. Remove the air conditioner assembly. 2. Remove air duct at foot level (left). 3. Remove the fixing screws (A). 4. Move the heater core (1) to the left....
Air conditioner filter — removal and installation Purpose Due to the filter built into the air conditioner, the air in the car is kept clean, both in the recirculation mode and in the outside air intake mode....
Air ducts and grilles — removal and installation Removing 1. Right windshield air duct; 2. Right ventilation duct; 3. Side section of the dashboard (right); 4. Overlay From a combination of devices; 5. Side section of...