Engine management system HR for vehicles Nissan Note 1
Fuel vapor recovery system
The fuel vapor recovery system is used to reduce hydrocarbon emissions from the fuel system into the atmosphere, which is achieved through the presence of activated...
The fuel vapor recovery system is used to reduce hydrocarbon emissions from the fuel system into the atmosphere, which is achieved through the presence of activated...
Basic Maintenance Procedures — Basic Checks
1. Start the check 1. Check whether there are any entries in the service log for recently performed repairs that could indicate the corresponding malfunction, and...
1. Start the check 1. Check whether there are any entries in the service log for recently performed repairs that could indicate the corresponding malfunction, and...
Checking the idle speed and ignition timing
Idle speed. Using the CONSULT-II tester Check the idle speed in idle mode "DATA MONITOR" using the CONSULT-II tester. Using GST scanner Check the idle speed. Ignition...
Idle speed. Using the CONSULT-II tester Check the idle speed in idle mode "DATA MONITOR" using the CONSULT-II tester. Using GST scanner Check the idle speed. Ignition...
Accelerator Pedal Release Position Learning
Description The procedure is a learning operation of the accelerator pedal release position by monitoring the output signal of the accelerator pedal position sensor. It...
Description The procedure is a learning operation of the accelerator pedal release position by monitoring the output signal of the accelerator pedal position sensor. It...
Closed Throttle Position Training
Description The procedure is a closed throttle position learning operation by monitoring the output signal of the throttle position sensor. It must be performed after...
Description The procedure is a closed throttle position learning operation by monitoring the output signal of the throttle position sensor. It must be performed after...
Idle Speed Air Supply Training
Description The procedure is an operation of training the air supply at idle speed, in which the engine speed is maintained within the normal range. It must be performed...
Description The procedure is an operation of training the air supply at idle speed, in which the engine speed is maintained within the normal range. It must be performed...
Checking fuel pressure
Fuel pressure relief 1. Remove the fuel pump fuse located in the IPDM E/R unit (microprocessor power distribution unit in the engine compartment). 2. Start the engine....
Fuel pressure relief 1. Remove the fuel pump fuse located in the IPDM E/R unit (microprocessor power distribution unit in the engine compartment). 2. Start the engine....
Troubleshooting — Engine Management System Component Locations
1. Ignition coil (with power transistor) and spark plug; 2. Electrovalve of the valve timing adjustment mechanism of the intake valves; 3. Refrigerant pressure sensor;...
1. Ignition coil (with power transistor) and spark plug; 2. Electrovalve of the valve timing adjustment mechanism of the intake valves; 3. Refrigerant pressure sensor;...
Troubleshooting — Vacuum Hose Routing
Note: When connecting the vacuum hose or purge hoses, do not use soapy water or solvent. For the location of the vacuum control system components, see " Schematic...
Note: When connecting the vacuum hose or purge hoses, do not use soapy water or solvent. For the location of the vacuum control system components, see " Schematic...
Location of contacts in the ECM connector
Standard voltage values at the ECM unit contacts Preparing for measurements 1. The ECM (1) is located on the left side of the engine compartment next to the battery. 2....
Standard voltage values at the ECM unit contacts Preparing for measurements 1. The ECM (1) is located on the left side of the engine compartment next to the battery. 2....
This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Similar information for other Nissan models
➜ Power unit: Engine management Nissan Murano 1 (2002-2007, petrol)
➜ Power unit: Engine management SR20DE Nissan Serena 2 (1999-2005)
➜ Power unit: Control systems Nissan Maxima 4 (1994-1999)
➜ Power unit: Engine management system Nissan Qashqai 1 (2006-2013)
➜ Powertrain QR25DE: Control system Nissan X-Trail 2 (2007-2013, petrol)
Link in different formats to this section
TEXTHTMLBB Code
- User manual
- Control devices
- Preparing to move
- Starting engine and driving
- Maintenance
- Technical information
- Power unit
- Engine repair CR
- Engine repair HR
- Engine lubrication system
- Cooling system (CR)
- Cooling system (HR)
- Fuel and exhaust system
- Engine management (CR)
- Engine management (HR)
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Drive shafts and axles
- Chassis
- Car suspension
- Brake system
- Steering
- Body
- Airbags (SRS)
- Doors, hood and locks
- Glasses and mirrors
- Exterior (external elements)
- Interior (internal elements)
- Air conditioning automatic
- Electrical equipment
- Equipment and devices
- Launch and charge system
- Headlights and lighting
- Windshield wipers and washers
- General information
- Introduction to guide
- Governing bodies
- Starting engine and driving
- Maintenance
- Power unit
- Engine repair
- Cooling system
- Heating and ventilation
- Power and exhaust system
- Ignition system
- Charge and launch systems
- Transmission
- Mechanical gearbox
- Automatic gearbox
- Clutch
- Drive shafts and hubs
- Chassis
- Brake system
- Car suspension
- Steering
- Body
- Exterior (external elements)
- Interior (internal elements)
- Electrical equipment
- Equipment and devices
- Electrical circuits
Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.