Car windshield wipers and washers Nissan Note 1
Windshield Wipers and Washers — Component and Connector Locations
1. IPDM E/R block E10, E11.E12 (in the engine compartment on the left) 2. BCM block M57, M58, M59 (view with the dashboard removed) 3. Data transfer connector 4....
1. IPDM E/R block E10, E11.E12 (in the engine compartment on the left) 2. BCM block M57, M58, M59 (view with the dashboard removed) 3. Data transfer connector 4....
Removal and installation windshield wiper arms, adjusting the wiper arm stop position
Removal 1. Turn on the engine with the wiper switch and then turn it off (auto stop). 2. Open the hood, remove the caps from the wiper arms, unscrew the fastening nuts....
Removal 1. Turn on the engine with the wiper switch and then turn it off (auto stop). 2. Open the hood, remove the caps from the wiper arms, unscrew the fastening nuts....
Removal and installation the windshield wiper drive assembly
Left hand drive 1. Wiper arm and brush assembly (right); 2. Windshield wiper drive assembly mounting bolts; 3. Windshield wiper drive assembly; 4. Wiper arm and brush...
Left hand drive 1. Wiper arm and brush assembly (right); 2. Windshield wiper drive assembly mounting bolts; 3. Windshield wiper drive assembly; 4. Wiper arm and brush...
Adjusting the washer nozzles
Adjusting the washer nozzles This model uses non-adjustable type washer nozzles. If necessary, make sure that the jet of cleaning fluid covers the area shown in the...
Adjusting the washer nozzles This model uses non-adjustable type washer nozzles. If necessary, make sure that the jet of cleaning fluid covers the area shown in the...
Location of washer tubes
1. Windshield washer tube; 2. Clamp; 3. Windshield and rear window washer reservoir; 4. Windshield washer nozzle (left); 5. Windshield washer nozzle (right); 6. Stop...
1. Windshield washer tube; 2. Clamp; 3. Windshield and rear window washer reservoir; 4. Windshield washer nozzle (left); 5. Windshield washer nozzle (right); 6. Stop...
Removal and installation the windshield washer nozzle
Removal 1. Remove the hood grille cover. See chapter Body . 2. Disconnect the washer pipe. 3. Press the latch (A) on the back of the windshield washer nozzle (1) and...
Removal 1. Remove the hood grille cover. See chapter Body . 2. Disconnect the washer pipe. 3. Press the latch (A) on the back of the windshield washer nozzle (1) and...
Checking the washer nozzle
Checking the check valve The shut-off valve is built into the washer pipe. Observe the direction of connection of the shut-off valve to the washer pipe.
Checking the check valve The shut-off valve is built into the washer pipe. Observe the direction of connection of the shut-off valve to the washer pipe.
Removal and installation the windshield wiper and washer switch
Removal 1. Remove the steering column cover. See chapter Body . 2. Disconnect the connector from the wiper and washer switch. 3. Pull the wiper and washer switch (1)...
Removal 1. Remove the steering column cover. See chapter Body . 2. Disconnect the connector from the wiper and washer switch. 3. Pull the wiper and washer switch (1)...
Removal and installation the washer reservoir
Removal 1. Remove the clamp (A) and turn the inlet pipe (1) away from the tank. 2. Remove the front bumper. See chapter Body . 3. Disconnect the connector from the...
Removal 1. Remove the clamp (A) and turn the inlet pipe (1) away from the tank. 2. Remove the front bumper. See chapter Body . 3. Disconnect the connector from the...
Removal and installation the windshield washer motor
Removal 1 Remove the protective cover from the front right wing. See the BODY chapter. 2. Disconnect the connector (1) from the motor, washer and disconnect the pipe....
Removal 1 Remove the protective cover from the front right wing. See the BODY chapter. 2. Disconnect the connector (1) from the motor, washer and disconnect the pipe....
Removal and installation the light and rain sensor
Removal 1. Remove the interior mirror. See chapter Body . 2. Remove the clamp and press the latches. 3. Remove the light and rain sensor. 4. Disconnect the connector...
Removal 1. Remove the interior mirror. See chapter Body . 2. Remove the clamp and press the latches. 3. Remove the light and rain sensor. 4. Disconnect the connector...
Rear Window Wiper and Washer — Component and Connector Locations
1. BCM block M57, M5B, M59 (view with the dashboard removed). 2. Data transfer connector. 3. Combination, switch (windshield wiper switch) MZZ 4. Rear window wiper motor...
1. BCM block M57, M5B, M59 (view with the dashboard removed). 2. Data transfer connector. 3. Combination, switch (windshield wiper switch) MZZ 4. Rear window wiper motor...
Rear window wiper and washer — standard voltage values at the contacts of the BCM unit and the IPDM E/R unit
Standard voltage values at the contacts of the VSM block Standard voltage values at the contacts of the IPDM E/R unit
Standard voltage values at the contacts of the VSM block Standard voltage values at the contacts of the IPDM E/R unit
Removal and installation the rear window wiper arm, adjusting the wiper arm stop position
Removal 1. Turn on the engine with the wiper switch and then turn it off (auto stop). 2. Remove the cap from the wiper arm and unscrew the mounting nut. 3. Lift the...
Removal 1. Turn on the engine with the wiper switch and then turn it off (auto stop). 2. Remove the cap from the wiper arm and unscrew the mounting nut. 3. Lift the...
Removal and installation the rear window wiper motor
Removal 1. Remove the rear window wiper arm from the vehicle. See "Removing and installing the rear window wiper arm, adjusting the wiper arm stop position". 2. Remove...
Removal 1. Remove the rear window wiper arm from the vehicle. See "Removing and installing the rear window wiper arm, adjusting the wiper arm stop position". 2. Remove...
Rear Window Wiper and Washer — Adjusting the Washer Nozzle
Adjust the washer nozzle as shown in the figure (see table No.1 below). Spray jet area h (height) l (width) φ (spray range of the jet) A 140 38 60 Adjust the washer...
Adjust the washer nozzle as shown in the figure (see table No.1 below). Spray jet area h (height) l (width) φ (spray range of the jet) A 140 38 60 Adjust the washer...
Removal and installation the rear window washer nozzle
1. Remove the upper brake light. See section " Lighting system ". 2. Disconnect the washer pipe (2) at the joint. Note: The washer tube can be accessed through the hole...
1. Remove the upper brake light. See section " Lighting system ". 2. Disconnect the washer pipe (2) at the joint. Note: The washer tube can be accessed through the hole...
Removal and installation the rear window wiper and washer switch, washer reservoir and rear window wiper and washer pump
Removal and installation the rear window wiper and washer switch See section " Lighting system ". Removal and installation the washer reservoir See section " Removal and...
Removal and installation the rear window wiper and washer switch See section " Lighting system ". Removal and installation the washer reservoir See section " Removal and...
Headlight washers — component and connector locations
1. IPDM block E/R1, E11, E12 (in the engine compartment on the left) 2. BCM block M57, M5B, M59 (view with the dashboard removed) 3. Data transfer connector 4. Headlight...
1. IPDM block E/R1, E11, E12 (in the engine compartment on the left) 2. BCM block M57, M5B, M59 (view with the dashboard removed) 3. Data transfer connector 4. Headlight...
Removal and installation headlight washer nozzles and washer reservoir
Removal 1. Remove the front bumper. See chapter Body . 2. Disconnect the tube from the headlight washer. 3. Remove the headlight washer nozzle from the front bumper....
Removal 1. Remove the front bumper. See chapter Body . 2. Disconnect the tube from the headlight washer. 3. Remove the headlight washer nozzle from the front bumper....
Removal and installation the headlight washer motor
1. Remove the front bumper. See chapter Body. 2. Disconnect the connector and hose from the headlight washer motor (1). 3. Pull the headlight washer motor in the...
1. Remove the front bumper. See chapter Body. 2. Disconnect the connector and hose from the headlight washer motor (1). 3. Pull the headlight washer motor in the...
Location of headlight washer tubes
1. Right headlight washer nozzle; 2. Washer reservoir; 3. Left headlight washer nozzle
1. Right headlight washer nozzle; 2. Washer reservoir; 3. Left headlight washer nozzle
This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Similar information for other Nissan models
➜ Electrical equipment: Windshield wipers and washers Nissan X-Trail 2 (2007-2013, petrol)
Link in different formats to this section
TEXTHTMLBB Code
- User manual
- Control devices
- Preparing to move
- Starting engine and driving
- Maintenance
- Technical information
- Power unit
- Engine repair CR
- Engine repair HR
- Engine lubrication system
- Cooling system (CR)
- Cooling system (HR)
- Fuel and exhaust system
- Engine management (CR)
- Engine management (HR)
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Drive shafts and axles
- Chassis
- Car suspension
- Brake system
- Steering
- Body
- Airbags (SRS)
- Doors, hood and locks
- Glasses and mirrors
- Exterior (external elements)
- Interior (internal elements)
- Air conditioning automatic
- Electrical equipment
- Equipment and devices
- Launch and charge system
- Headlights and lighting
- Windshield wipers and washers
- General information
- Introduction to guide
- Governing bodies
- Starting engine and driving
- Maintenance
- Power unit
- Engine repair
- Cooling system
- Heating and ventilation
- Power and exhaust system
- Ignition system
- Charge and launch systems
- Transmission
- Mechanical gearbox
- Automatic gearbox
- Clutch
- Drive shafts and hubs
- Chassis
- Brake system
- Car suspension
- Steering
- Body
- Exterior (external elements)
- Interior (internal elements)
- Electrical equipment
- Equipment and devices
- Electrical circuits
Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.