Removing
1. Pull out the clip (A) and open the intake manifold (1) away from the tank.
2. Remove the front bumper. See chapter Body.
3. Disconnect the connector from the washer motor.
4. Loosen the screws (A) and a nut (IN).
5. Disconnect the washer tube (2) and remove the washer reservoir (1) from the car.
Installation
Installation is carried out in the reverse order of removal, taking into account the following:
Attention: After installation, add water to the top of the washer reservoir inlet and check for water leaks.
Washer reservoir fixing nut: Tightening torque: 4.5 N*M (0.46 kg m)
Washer reservoir fixing screws: Tightening torque: 4.5 Nm (0.46 kg m)