Vehicle passive safety system Nissan Qashqai 1 (J10)
Seat Belt Maintenance Precautions Attention. Before removing the front seat belt pretensioner, turn off the ignition, disconnect both wires from the battery, and wait at least 30 minutes. Do not use...
Seat belts — device Note. To remove or install seat belts, it is recommended that you follow the illustrations below. Second row outer seat belt: 1. Outer seat belt anchor bolt. 2. Outer...
Child holder system 1. LATCH child holder system (Lower Anchor & Tether for Children) Attention. Replace anchor bolts with new ones if they are deformed or worn. Removal and installation...
Contact disk — device 1. Contact disk. 2. Steering wheel. 3. Driver's airbag module wiring connectors. 4. Steering column assembly. 5. The lower casing of the steering column. 6. Mandrel of...
Contact disk — removal and installation Removing Attention. Before starting work, turn off the ignition, disconnect both battery terminals and wait at least three minutes. Do not use pneumatic or electric...
Front Passenger Airbag Module — Device 1. Front passenger airbag module. 2. Instrument panel assembly. Note. : replace the part with a new one after each removal.
Front Passenger Airbag Module — Removal and Installation Removing Attention. Before starting work, turn off the ignition, disconnect both battery terminals and wait at least three minutes Work away from the airbag module, not...
Curtain Air Curtain Module — Device 1. Curtain air curtain module 2. Curtain airbag module igniter. Note. : replace the part with a new one after each removal. : clip. : clip.
Curtain airbag module — removal and installation Removing Attention. Before starting work, turn off the ignition, disconnect both battery terminals and wait at least three minutes. Do not use pneumatic or electric...
Side airbag module — device 1. Side airbag module. 2. Front seat back base. A. Side airbag module connector. Note. : replace the part with a new one after each removal.
Side airbag module — removal and installation Removing Attention. Before starting work, turn off the ignition, disconnect both battery terminals and wait at least three minutes. Do not use pneumatic or electric...
Shock sensors — removal and installation Attention. Before starting work, turn off the ignition, disconnect both battery terminals and wait at least three minutes. Do not use pneumatic or electric tools....
Airbag control unit — device 1. Airbag control unit. A. Wire connector. Note. : replace the part with a new one after each removal.
Airbag control unit — removal and installation Attention. Before starting work, switch off the ignition, disconnect both terminals of the battery and wait at least three minutes Before disconnecting the airbag...
Special tools and fixtures Note. Instructions for activating airbag and pretensioner modules for disposal are included with the dedicated disposal equipment.