Mudguards:
1. Front mudguard (if equipped).
2. Rear mudguard (if equipped).
Note. : clip.
wheel arch moldings:
1. Front wheel arch molding.
2. Molding rear wheel arch.
A. Clamps A.
B. Clamps B.
Roof side moldings:
1. Roof side molding.
2. Clamp side roof molding.
3. Retainer side roof molding.
Note. To prevent damage to the body, wrap the clamp remover with a rag.
1. Roof rails.
Note. To remove the railing, the curtain airbag module must be removed from the corresponding side.
1. Front door panel.
2. Rear door panel.
3. Side seal of tailgate connector.
4. Rear door window frame molding.
5. Seal the rear door window frame molding.
6. Adhesive tape.
Note.
- : clip.
- Rear door window frame molding is removed from top to bottom.
1. External molding of the front door.
2. Front door panel.
3. Exterior tailgate molding.
4. Rear door panel.
5. Mounting screw.
6. Adhesive screw cap.
Note.
- : clip.
- To remove the outer molding of the door, insert a screwdriver wrapped with rags, as shown in the figure, and then, turning the answer, remove the molding from back to front.
Lower exterior door moldings:
1. External lower molding of the front door.
2. Exterior tailgate molding.
3. Adhesive tape.
Note. : clip.
Door connector seals:
1. Front door connector seals.
2. Rear door connector seal.
3. Front door panel.
4. Rear door panel.
5. External lower molding of the front door.
6. External lower molding of the rear door.
7. Sealing the side connector of the rear door.
tailgate lining:
1. Facing the tailgate.
2. Trunk door panel.
3. License plate light.
4. Tailgate opening switch.
5. Wiring.
Note. To remove the tailgate trim, unscrew the nuts (A) and fixing clips (IN).