Tightening this connection is necessary in case of leakage and air suction (a hissing sound can be heard through a hose about 60 cm long near the base of the body). Remove the air filter, after marking and disconnecting the hoses, and tighten the throttle body nuts and bolts to the specified torque. If tightening does not produce results, remove the throttle body and replace the gasket (Chapter 4). Install the filter and connect the hoses.
[The article was copied from here: NissanBook.ru]
Checking the throttle body mount (Nissan Terrano 1)
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This article has been reviewed: Andrey Lazarev
Similar information for other Nissan models
➜ Checking the condition and replacing the throttle body Nissan Maxima 4 (1994-1999)
➜ Checking the condition of the body Nissan Almera 1 (1995-2000)
➜ Checking and lubricating the throttle linkage Nissan Primera 1 (1990-1996, petrol)
➜ Throttle body — removal and installation Nissan Sunny 7 (1990-1998)
➜ Throttle body — removal and installation Nissan Bluebird T12 (1986-1991)
➜ Checking the coolant level Nissan Murano 1 (2002-2007, petrol)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Engines 4-cylinder
- Engines 6-cylinder
- Engine overhaul
- Cooling and ventilation
- Fuel and exhaust systems
- Engine electrical equipment
- Decreased toxicity
- Transmission
- Mechanical gearbox
- Automatic gearbox
- Clutch and drive shafts
- All-wheel drive system
- Chassis
- Brake system
- Car suspension
- Steering
- Body and electrical equipment
- Body elements
- Doors, locks and windows
- Equipment and devices
Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.