Electrical equipment and devices of the car Nissan Serena 2 (C24)
Rear heater Tubing and hose routing Disassembly and assembly Wiring diagram
Generator — Models with SR engine Removing 1. Disconnect the negative cable from the battery. 2. Disconnect the intermediate wiring connector of the air conditioning compressor and generator, unscrew the...
Generator — Models with YD engine Removing 1. Disconnect the negative cable from the battery. 2. Disconnect the intermediate wiring connector of the air conditioning compressor and generator, unscrew the...
Generator Input/Output Standard Voltages Attention: The above measurements are carried out when the electrical consumers are switched off (e.g. headlights, air conditioning fan motor and rear window defroster)....
Diagnostics of malfunctions of the generator Note: Diagnostic data is load dependent. Keep the radiator fans running at a sufficient speed while the engine is running. Before proceeding with the diagnosis, check...
Cigarette lighter, combination switch and ignition switch Cigarette lighter Preparatory work Remove panel B. Electrical outlet Combination switch and ignition switch Attention: When installing the combination switch, the mark...
Diagnostics of malfunctions of a combination of devices System Description The speedometer, tachometer, odometer and mileage indicator, fuel gauge and low fuel warning lamp, as well as the temperature gauge are combined in...
Checking the components of the instrument cluster Checking the speedometer, tachometer, fuel gauge and temperature gauge Remove the corresponding pointer from a combination of devices and measure resistance between the...
Front and rear sonars Front corner sonars Before removing the front corner sonar, remove the fender guard and front bumper molding. Rear corner sonars Before removing the rear corner sonar,...
Sonar Diagnostics Location of components Wiring diagram Standard input/output voltages of the sonar control unit
Radio receiver with electronic tuning Fixed Tuning Stations The possibility of fixed tuning to 12 stations is provided: 6 pcs. AM band and 6 pcs. FM. Example: Tuning to a station with a broadcast frequency...
Removal and installation of the radio receiver Before removal of an audiosystem remove an overlay From the instrument panel. Note: The electronically tuned radio and trim are attached with various screws. Disconnect...
Front and rear speakers Removal and installation To access the front or rear speaker, remove the front or rear door trim. A-pillar tweeters 1. Remove the instrument panel side section and...
Roof Antenna (Manual) Removal and installation 1. Sunroof Models: Remove the front right roof molding. Note: If the molding cannot be removed, break the clips and remove it. Caution: If clips...