Electrical equipment and devices of the car Nissan Sunny 7 (B13)
Electrical equipment — general information The body electrical system includes all lighting bulbs, signal lights and headlights, a wiper and washer system, passenger compartment electrical equipment, as well as...
Lamp Ratings Lamp Ratings (Tue) headlights 60/ 55 spotlight 55 Front fog lights 55 Front direction indicator 21 Front marker lamp 5 Turn signal repeater 5 Brake light/ Rear marker...
Troubleshooting — general information Attention! Read about precautions (see section 14 ) before starting work. Attention! The following tests are designed to test basic electrical circuits and should not be...
Fuses and relays — check and replace Circuit breakers Fuses break the circuit in case of accidental short circuits. The main fuses are located in the block on the driver's side. To access the fuse, open the...
Switches — removal and installation Attention! When removing any switch, disconnect the battery from ground. Ignition switch and steering lock 1. See subsection 12.10 . Steering column switch combination...
Outdoor Lighting Lamps — Replacement New lamps must fully match the ones being replaced. When replacing, make sure the contacts are clean and secure. Headlights 1. open the hood 2. Press the latches and...
Interior lighting lamps — replacement New lamps must fully match the ones being replaced. When replacing, make sure the contacts are clean and secure. Doorway lamp 1. Carefully pry up and remove the optical...
Outdoor lighting devices — removal and installation Attention! When removing any light device, disconnect the battery from the ground. Headlights (sedan and hatchback) 1. Remove the turn signal cover. 2. Remove the front...
Headlight adjustment Performed at a Nissan car service. Some vehicles are equipped with a headlight beam corrector, which must be set to a position corresponding to the actual vehicle load.
Instrument panel — removal and installation Attention! This description only applies to vehicles without airbags. 1. Disconnect the battery from the ground. 2. Dashboard cover with ventilation nozzle. 3. Loosen...
Sound signal — removal and installation 1. Disconnect the battery from the ground. 2. Remove the front grille. 3. Disconnect wires from signal. 4. Turn away bolts (indicated by an arrow) and remove the signal...
Speedometer drive cable — removal and installation Removing 1. Remove the instrument panel. 2. In the engine compartment, unscrew the clutch and remove the cable from the gearbox. 3. Remove the cable from the brackets...
Wiper arm — removal and installation Removing 1. Turn on the cleaner and move the brushes to the extreme position. 2. If the cleaner will be removed, then mark the position of the brushes with adhesive...
Wiper parts — removal and installation Tank 1. Turn the bottle neck clockwise and remove. 2. Disconnect the battery from the ground. 3. Raise the front of the car. 4. Remove the protective wing panel. 5....
Radio — removal and installation Attention! Make sure you know the code for decoding the radio. 1. Disconnect the battery from the ground. 2. Remove the middle panel. 3. Loosen the radio screws. 4. Pull...
Speakers — removal and installation Front door speaker 1. Remove the door panel. 2. Loosen the screws (indicated by arrows) and get the speaker in the case, disconnect the connector. 3. If necessary,...
Antenna — removal and installation Antenna mounted in the rear window 1. Such an antenna is installed on parts of cars and is combined with a glass defroster. If you suspect a malfunction, contact the car...
Airbags of the safety system Airbags are designed to protect the driver and front seat passenger in the event of a collision. The system is brought to a state of readiness after the ignition is...