Car manual transmission Nissan Sunny 7 (B13)
Manual gearbox — removal and installation
The vehicles are equipped with a transverse gearbox with a main gear and differential, the housing is cast from an aluminum alloy. The gearbox mechanism includes a...
The vehicles are equipped with a transverse gearbox with a main gear and differential, the housing is cast from an aluminum alloy. The gearbox mechanism includes a...
Technical data of mechanical transmission
Gearbox type Mechanical 5-speed with 1 reverse gear, all gears with synchronizers except reverse gear Designation RS5F30A (1.4 l), RS5F31A (1.6 l) Gear ratios For 1.4L...
Gearbox type Mechanical 5-speed with 1 reverse gear, all gears with synchronizers except reverse gear Designation RS5F30A (1.4 l), RS5F31A (1.6 l) Gear ratios For 1.4L...
Gear Shift Mechanism — Removal and Installation
Removal 1. Remove the center section of the front panel. 2. Raise the front of the vehicle and support it on stands. 3. Disengage the gear shift rod spring. 4. Unscrew...
Removal 1. Remove the center section of the front panel. 2. Raise the front of the vehicle and support it on stands. 3. Disengage the gear shift rod spring. 4. Unscrew...
Replacing manual transmission seals
Axle shaft seal 1. Raise the rear of the vehicle and support it on stands. 2. Drain the oil from the gearbox. 3. Remove the axle shaft from the gearbox housing (see...
Axle shaft seal 1. Raise the rear of the vehicle and support it on stands. 2. Drain the oil from the gearbox. 3. Remove the axle shaft from the gearbox housing (see...
Neutral Position Sensor — Checking, Removing and Installing
Sensor location Sensor (installed only on vehicles with a catalytic converter) screwed into the bottom of the gearbox housing on the right side. Checking, removing and...
Sensor location Sensor (installed only on vehicles with a catalytic converter) screwed into the bottom of the gearbox housing on the right side. Checking, removing and...
Reverse signal switch — removal and installation
Switch location The switch is a plunger type, screwed into the bottom of the gearbox housing on the left side. Checking, removing and installing 1. Before checking the...
Switch location The switch is a plunger type, screwed into the bottom of the gearbox housing on the left side. Checking, removing and installing 1. Before checking the...
Speedometer reducer — removal and installation
The speedometer gearbox is located next to the right axle shaft. Removal 1. Raise the rear of the vehicle and support it on stands. 2. Loosen the union nut and...
The speedometer gearbox is located next to the right axle shaft. Removal 1. Raise the rear of the vehicle and support it on stands. 2. Loosen the union nut and...
This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Similar information for other Nissan models
➜ Transmission: Mechanical gearbox Nissan Maxima 4 (1994-1999)
➜ Transmission: Mechanical gearbox Nissan Bluebird T12 (1986-1991)
➜ Transmission: Manual gearbox Nissan Almera 1 (1995-2000)
➜ Transmission: Mechanical gearbox Nissan Note 1 (2004-2013)
➜ Transmission: Mechanical gearbox Nissan Terrano 1 (1986-1995, petrol)
➜ Transmission: Mechanical gearbox Nissan X-Trail 2 (2007-2013, petrol)
Link in different formats to this section
TEXTHTMLBB Code
- General information
- User manual
- Faults en route
- Maintenance
- Power unit
- Petrol engines (1.4 and 1.6)
- Engine overhaul (1.4 and 1.6)
- Petrol engines (2.0)
- Engine overhaul (2.0)
- Diesel engine
- Cooling system
- Heating and ventilation
- Power system (carburetor)
- Power system (injector)
- Fuel injection system
- Single point injection
- Multi-point injection
- Decreased toxicity
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Drive shafts
- Chassis
- Brake system
- Car suspension
- Steering
- Body
- Body repair
- Body elements
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical circuits