Electrical equipment of the car engine Nissan Sunny 7 (B13)
Engine Starting System — General Information
Battery Some vehicles are equipped with maintenance-free batteries. Starter Some vehicles are equipped with starters with planetary gearboxes. Precautionary measures It...
Battery Some vehicles are equipped with maintenance-free batteries. Starter Some vehicles are equipped with starters with planetary gearboxes. Precautionary measures It...
Technical data of the engine starting system
On-board network voltage +12 V, connected to ground (-) of the battery Battery: Capacity 60 or 65 Ah. Generator: Type Hitachi or Mitsubishi Rated current 65 (carburetor...
On-board network voltage +12 V, connected to ground (-) of the battery Battery: Capacity 60 or 65 Ah. Generator: Type Hitachi or Mitsubishi Rated current 65 (carburetor...
Battery — Removal, Checking and Installation
The battery is located on the left side of the engine compartment. Examination Standard batteries 1. If the vehicle has a low mileage, it is recommended to check the...
The battery is located on the left side of the engine compartment. Examination Standard batteries 1. If the vehicle has a low mileage, it is recommended to check the...
Charging system — check
1. If the battery charge indicator lamp on the instrument panel does not light when the ignition is on, first check the lamp circuit. 2. If no defects are found, then...
1. If the battery charge indicator lamp on the instrument panel does not light when the ignition is on, first check the lamp circuit. 2. If no defects are found, then...
Generator — removal, inspection and installation
Removal 1. Disconnect the battery from ground. 2. Remove the belt from the alternator pulley. 3. Disconnect the wires. 4. Remove the upper and lower bolts and remove the...
Removal 1. Disconnect the battery from ground. 2. Remove the belt from the alternator pulley. 3. Disconnect the wires. 4. Remove the upper and lower bolts and remove the...
Engine starting system — check
If the starter does not turn on when you turn the key in the ignition switch, this may be due to the following reasons: battery is faulty; contamination of power wire...
If the starter does not turn on when you turn the key in the ignition switch, this may be due to the following reasons: battery is faulty; contamination of power wire...
Oil Pressure Sensor — Removal and Installation
Removal 1. Raise the front of the vehicle and support it on stands. 2. Disconnect the battery from ground. 3. Disconnect the connector from the sensor (the sensor is...
Removal 1. Raise the front of the vehicle and support it on stands. 2. Disconnect the battery from ground. 3. Disconnect the connector from the sensor (the sensor is...
Starter — removal and installation
Removal 1. Disconnect the battery from ground. 2. Raise the front of the vehicle and support it on stands. 3. Loosen the bolts and move the manifold stand to the side....
Removal 1. Disconnect the battery from ground. 2. Raise the front of the vehicle and support it on stands. 3. Loosen the bolts and move the manifold stand to the side....
Ignition system — general information
Carburetor engines without a neutralizer The ignition system of these engines consists of an ignition coil and a distributor with an integral switch, which is triggered...
Carburetor engines without a neutralizer The ignition system of these engines consists of an ignition coil and a distributor with an integral switch, which is triggered...
Technical data of the ignition system
System type On carburetor engines: - without neutralizer Contactless electronic - with neutralizer Contactless with control from the ECC processor unit Cylinder firing...
System type On carburetor engines: - without neutralizer Contactless electronic - with neutralizer Contactless with control from the ECC processor unit Cylinder firing...
Checking the ignition system
Warning! Observe safety precautions to prevent electric shock. Turn off the ignition before connecting devices. Carburetor engines without a neutralizer Ignition...
Warning! Observe safety precautions to prevent electric shock. Turn off the ignition before connecting devices. Carburetor engines without a neutralizer Ignition...
Ignition coil — removal, inspection and installation
Only for carburetor engines without a neutralizer. Removal 1. Disconnect the battery from ground. 2. Turn away from the coil (located on the left side of the cylinder...
Only for carburetor engines without a neutralizer. Removal 1. Disconnect the battery from ground. 2. Turn away from the coil (located on the left side of the cylinder...
Ignition distributor — removal and installation
Removal 1. Disconnect the battery from ground. 2. Disconnect the latches, unscrew the screws. 3. Remove the cover. 4. Remove the gasket. 5. Disconnect the connector. 6....
Removal 1. Disconnect the battery from ground. 2. Disconnect the latches, unscrew the screws. 3. Remove the cover. 4. Remove the gasket. 5. Disconnect the connector. 6....
Integral module — removal and installation
Only for carburetor engines without a neutralizer. Removal 1. Remove the distributor. 2. Remove the runner. Hitachi distributor 3. Place a mark on the part of the...
Only for carburetor engines without a neutralizer. Removal 1. Remove the distributor. 2. Remove the runner. Hitachi distributor 3. Place a mark on the part of the...
Transistor Switch Module — Removal and Installation
Carburetor engines with a neutralizer The switch is mounted on the left suspension cap. 1. Disconnect the battery from ground, disconnect the connector from the switch....
Carburetor engines with a neutralizer The switch is mounted on the left suspension cap. 1. Disconnect the battery from ground, disconnect the connector from the switch....
Ignition Timing — Checking and Setting
Checking and setting the ignition is performed using a stroboscope. The pulley crown has installation marks at 5° intervals. The first mark is located 20° before TDC,...
Checking and setting the ignition is performed using a stroboscope. The pulley crown has installation marks at 5° intervals. The first mark is located 20° before TDC,...
This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Similar information for other Nissan models
➜ Power unit: Engine electrical equipment Nissan Patrol 4 (1987-1997, petrol)
➜ Power unit: Engine electrical equipment Nissan Primera 1 (1990-1996, petrol)
➜ Power unit: Engine electrical equipment Nissan Qashqai 1 (2006-2013)
➜ Power unit: Engine electrical equipment Nissan Terrano 1 (1986-1995, petrol)
➜ Power unit: Engine electrical equipment Nissan Maxima 4 (1994-1999)
Link in different formats to this section
TEXTHTMLBB Code
- General information
- User manual
- Faults en route
- Maintenance
- Power unit
- Petrol engines (1.4 and 1.6)
- Engine overhaul (1.4 and 1.6)
- Petrol engines (2.0)
- Engine overhaul (2.0)
- Diesel engine
- Cooling system
- Heating and ventilation
- Power system (carburetor)
- Power system (injector)
- Fuel injection system
- Single point injection
- Multi-point injection
- Decreased toxicity
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Drive shafts
- Chassis
- Brake system
- Car suspension
- Steering
- Body
- Body repair
- Body elements
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical circuits
Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.