Table of contents: Removal ↓ Installation ↓
Removal
1. Turn on the cleaner and move the brushes to the extreme position.
2. If the wiper blade is to be removed, mark the position of the brushes with adhesive tape.
3. Loosen the brush lever axle nut.
5. When removing the rear window wiper arm, disconnect the washer hose.
6. Remove the lever from the axle by lifting the brush. Remember the location of the left and right levers.
Installation
1. Clean the splines in the lever and on the axle.
2. Install the brush levers in their original places, align the brushes with the tapes glued during disassembly.
3. When installing the headlight washers, tighten the axle nut while holding the lever below the stops at the bottom of the headlight.
4. Tighten the nut to the specified torque and replace the protective cap.