Table of contents: Headlights (sedan and hatchback) ↓ Front direction indicator lamp ↓ Front turn signal repeater lamp ↓ Front fog lights ↓ Spotlight ↓ Rear light unit ↓
Caution: When removing any lighting device, disconnect the battery from the ground.
Headlights (sedan and hatchback)
1. Remove the turn signal lamp.
2. Remove the front grille.
3. Disconnect the connectors.
4. Remove the two side screws.
5. Unscrew the two rear nuts.
6. Remove the headlight.
7. Installation is carried out in the reverse order. Check the reliability of the lower hinge installation. Check the headlight adjustment (see subsection 14.8).
Front direction indicator lamp
8. Cm. subsection 14.5 (the photo shows the front turn signal connector).
Front turn signal repeater lamp
9. Cm. subsection 14.5.
Front fog lights
10. Cm. subsection 14.5.
Spotlight
11. Cm. subsection 14.5.
Rear light unit
12. Remove the lamp holder.
 |
 |
13. Unscrew the four nuts (photo on the left), remove the bracket (photo on the right).
14. Remove the rear light assembly. The assembly is secured with adhesive sealant.
15. Clean the headlight assembly and the edge of the body opening from any remaining sealant.
16. Apply sealant to the edge of the headlight assembly.
17. Install the light assembly in reverse order.