Table of contents: Block headlights ↓ Fog lights ↓ Front and side direction indicators ↓ License plate light and high level…↓ Rear combination light bulbs ↓ Salon lamp ↓
Note: Replace bulbs only with bulbs of the same type. Before replacing a bulb, make sure that the corresponding lighting device is switched off. Do not handle the bulb with bare fingers, use a clean towel or cotton gloves. Fingerprints left on the bulb evaporate and settle on the reflector, which is especially noticeable on headlights and fog lights. Accidental fingerprints should be removed with an alcohol-soaked cloth. Do not wipe headlight reflectors covered with a protective varnish with a dry, hard cloth, or use any cleaners or solvents for this purpose. Use soft, damp cloths.
Warning! Halogen bulbs are under pressure and may crack. Therefore, when replacing them, wear protective glasses and gloves. When replacing xenon bulbs, there is a risk of injury due to high voltage! Be sure to turn off the headlights and disconnect the electrical wiring from the battery. After replacing, briefly switch the headlight on and off to relieve residual voltage. As a safety precaution, wear boots with rubber soles.
1. Turn off the ignition and the corresponding lighting device, disconnect the negative cable from the battery.
2. After installing the new lamp, check its operation.
Block headlights
Headlight bulb installation components
1. To replace the halogen lamp low and high beam disconnect its connector, remove the rubber cover and spring holder.
2. To replace the parking light bulb, turn its socket counterclockwise and pull out the bulb.
Fog lights
1. Remove the corresponding wheel arch liner and bumper (see Chapter Body).
2. Turn the lamp holder counterclockwise and pull out the lamp.
Front and side direction indicators
1. To replace the front turn signal bulb, remove the decorative radiator grille (see Chapter Body), and to replace the side turn signal lamp - the side indicator (see section Removal, installation and adjustment of lighting fixtures).
2. Turn the lamp holder counterclockwise and pull out the lamp.
Removal the front turn signal lamp
Removal the side turn signal lamp
License plate light and high level brake light
1. Remove the appropriate lighting fixture (see section Removal, installation and adjustment of lighting fixtures).
2. Turn the lamp holder counterclockwise and pull out the lamp.
Removal the license plate light bulb
Removal the high level brake light bulb
Rear combination light bulbs
1. Remove the rear combination light (see section Removal, installation and adjustment of lighting fixtures).
2. Release the lamp holder from the clips.
3. Remove the desired lamp from the holder.
Salon lamp
1. Remove the interior light (see section Removal, installation and adjustment of lighting fixtures) and remove the lamp from it.