Headlights
1. open the hood
2. Press the latches and disconnect the connector.
3. Remove the cover by turning counterclockwise.
4. Remove the rubber boot.
5. Remove the lamp holder by pressing on the latch.
6. Take out the lamp.
7. Hold a new lamp only through a clean cloth, without touching it with your fingers.
8. Install the new bulb like this. so that the protrusion of the holder enters the recess in the headlight housing. Put on the cover with the inscription up and connect the connector.
Marker lamp
1. Open the hood.
2. Press the latches and disconnect the connector.
3. Remove the lamp holder by turning it counterclockwise.
4. Remove the lamp from the holder.
5. Insert new bulb and install in reverse order.
Turn indicator
1. Open the hood and unscrew the screws of the turn signal lamp cover in its upper outer part.
2. Disconnect the lower hinge and pry and carefully remove the cover from the wing.
3. Remove the lamp holder by turning it counterclockwise.
4. The lamp is fixed in the holder with a bayonet connection.
5. Install the new bulb in reverse order. When installing, make sure that the protrusion on the ceiling goes into the hole in the body.
Turn signal repeater
1. Move the cover forward and disconnect from the wing panel.
2. Remove the cover, unscrew the holder counterclockwise.
3. Remove the lamp by pulling it out of the holder.
4. Install the new bulb in reverse order.
Spotlight
1. Unscrew the two screws securing the spotlight, do not touch the adjusting screws.
2. Take out the spotlight, remove the back cover by turning counterclockwise.
3. Get a lock ring and a lamp, disconnect a socket.
4. Handle the lamp only with a clean cloth.
5. Insert a new lamp, aligning the protrusion and recess in the lampshade.
6. Secure the lamp with a retaining ring, attach the connector.
7. Screw on the cover, install the cover and tighten the screws.
Front fog lights
1. Loosen the two screws, do not touch the beam adjustment screws.
2. Disconnect a socket, get a lock ring and a lamp.
3. Install the lamp in reverse order.
Rear lamp combination
1. Open the trunk lid (cargo compartment).
2. Remove the latch and open the hatch in the rear trim.
3. Take out the lamp holder.
4. The lamps are fixed in the holder with a bayonet connection.
5. Replace the lamp and install the holder in reverse order. Mounting bosses are provided on the brake/position light bulb.
License plate lamp
1. Unscrew the two screws and remove the cover from the rear cover.
2. Pull and remove the lamp.
3. Install the new bulb in reverse order.