Table of contents: Outdoor lighting ↓ Interior lighting ↓
Outdoor lighting
Replacing bulbs in fog lights
Replacing the bulbs is done in the same way as the main headlights. Please follow all the instructions in the section "Headlights".
Adjusting fog lights
Before adjusting, check the tire pressure and adjust it to normal if necessary. The car must be on a level surface and fully loaded. There must be a person or equivalent load in the driver's seat.
The adjustment is made by turning the screws shown in the figure.
Checking the turn signal and hazard warning flasher
Before checking, make sure that the lamps are in good condition and have the correct power.
Connect the battery and test lamp as shown in the figure. The lamp should flash when voltage is applied to the circuit.
Lamps used
Lamp power, W:
- Front direction indicators - 21
- Side lights - 5
- Fog lights - 55
- Side direction indicators - 5
- Rear combination lights:
- Direction indicators - 21
- Brake lights/side lights - 21/5
- Side lights - 5
- Reversing lights - 21
- Rear fog lights - 21
- License plate lights - 5
- Additional brake lights:
- Incandescent bulbs (sedan) - 5 (x 6)
- Incandescent lamps (hatchback) - 21
- LED type - 4.6
Interior lighting
Lamps used
Lamp power, W:
- Interior light - 10
- Individual lighting lampshade - 10
- Trunk light - 3.4